Jump to content
SAU Community

Recommended Posts

Hey Guys

I've just upgraded my wheels so my 33 GTR rims are up for sale. They are a fully forged item. 17x9 from memory.

They are in good condition. I have had them on my car for less than 8 months during which I have done less than 4000ks on them.

I had Bridgestone RE001 245s fitted all around when i purchased the car. These tyres cost $340 each! As you can see from the pictures below, 99% of the tread is still there. You can even see the red factory markings on the tyre.

Asking $1300 for the wheels and tyres. It's very reasonable considering the tyres alone cost me more than that.

Please find pictures attached.

I also have a set of 17" advan trispoke wheels for sale. They are in good nick except one of the wheels was damaged and requires repair. Tyres aren't roadworthy on them either. Would love $500 for them but throw me a reasonable offer and I'll consider it.

I'm located in Oakhurst (western sydney). Pick up only (frieght will b heeps).

Send me a private message or txt me on .

Cheers

post-44179-0-07066300-1298848672_thumb.jpg

post-44179-0-33175400-1298848706_thumb.jpg

post-44179-0-20321000-1298848742_thumb.jpg

post-44179-0-70783000-1298848779_thumb.jpg

post-44179-0-31328700-1298848850_thumb.jpg

post-44179-0-50933800-1298848909_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/355501-r33-gtr-rims-with-re001s/
Share on other sites

i have no need for the tyres alone so I wont be seperating

I can send to anywhere in australia at buyer's expense.... I have no idea how much it will cost to send to Tasmania...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Exhaust end of this month, and then tune after that whenever there is availability. Still tossing up between a pure 98 tune or a flex 98/e85 combo.  The (lack of) milage in e85 isnt great. Start to get anxiety if i go for a long drive and there arent any united servo's nearby
    • I mean I can be OCD'y but this is really over the top. At that point why not just run a full wideband fuel controller? Especially if you run 3 widebands. The system works pretty well, which is trimming low load stuff to be within a few percent of the base map. Pre-engine _change_ the base map was only 1-2% off, depending on ambient temp, elevation, etc. Under load the LS is really very straightforward to tune, enough that a wideband closed loop would be overkill. If I really cared (and I hope I don't) I can always just go back to the MAF system the car actually came with. Which does all those nice calculations for me (temp, altitude, etc), now that you can buy 102mm MAF's that do not cause restrictions.
    • Good afternoon Team , just a quick update on performance mods  Current Mods list (Installed) HKS - Power Editor (Came with the car) looks to be some kind of boost controller RV37 Skyline 400R (SKYLINE) | FUJITSUBO  - Cat Back  RV37 Skyline 400R (SKYLINE) | FUJITSUBO  - Front Pipe AMS  - INFINITI Q50/Q60 RED ALPHA COLD AIR INTAKE KIT AMS  - Performance Heat Exchanger Intercooler Not Yet AMS Alpha Performance Full Race Down Pipes  - to be installed in May 
    • I'd be installing 2x widebands and using the NB simulation outputs to the ECU.
    • Nah, it's different across different engines and as the years went on. R32 era RB20, and hence also RB26, the TPS SWITCH is the idle command. The variable resistor is only for the TCU, as you say. On R33 era RB25 and onwards (but probably not RB26, as they still used the same basic ECU from the R32 era), the idle command is a voltage output of close to 0.45V from the variable resistor.
×
×
  • Create New...