Jump to content
SAU Community

Recommended Posts

  On 13/03/2012 at 7:45 PM, Excuses said:

Ill b attending thursday if we can get numbers again. Think its morayfield this week unless we want nandos at carseldine. Im easy, i like the drive.

I wont b at happys, car service this sat on 2 cars and some solicitor crap to do

thought we were going to the westies this week

  On 14/03/2012 at 6:47 AM, Joe Nash said:

thought we were going to the westies this week

I have no idea where that is, or where morayfield is lol... I only know carseldine because its near my work...

in brisbane there is two groups that meet each week, sometimes we go over to the other side of brisbane where the other group meets up, and catch up with them, plus there is ice cream

oh yeah, morayfield is about 20 minutes north of carsaldine, most of the northsiders reside that way

  On 14/03/2012 at 6:47 AM, Joe Nash said:

thought we were going to the westies this week

If we can get a decent group going its possible, i am yet unconfirmed now but ill update later during the day

lol.....i totally would, but im buggered from a late night last night and wont be heading out tonight at all. Beer is about to be consumed, and Mass Effect 3 to be played!

sry for the late heads up

I won't be heading out, my partner isn't feel too crash hot atm, and this was my last chance as i am now permanent afternoons, maybe we can organize a monthly weekend meet sometime

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • E10 is pretty tightly regulated in percentage. Too much and engines can't adapt. Every incentive is against them to have too little ethanol though. The more ethanol the higher the octane.
    • Yeah i have R34 with factory small box and now RB25DET NEO swapoed and iam planning to upgrade to big box.  So i would be good as long as i do not change diff? 
    • Based off what you’ve said here, I think I’ve figured out a good bit of what I’ve done wrong -  So on the line going from the PCV valve to carbon canister, there’s a T joint that is pretty much right next to that lower port - I hadn’t noticed that the hose in the diagram was curved to attach onto the carb, so I was putting that line for the lower port onto the PCV line / carbon canister line instead. I’m going to have a flick through the manual again tomorrow and should hopefully find a diagram that’ll show me where that T joint should be connected to. Timing also 100% needs to be sorted out as well, should be able to tackle that tomorrow as well. Definitely feel like I should be on the right track now though. 
    • The screw is for idle (pilot circuit) mixture adjustment. Else, I'm confused ~ the diagram shows 2 carby ports, and the intake manifold port, but you're suggesting the "2nd port on the back of the carb that isn’t mentioned in the diagrams" ...yet, both carby ports are shown...que?... ...in any event, that port should be connected, but if not (like it is now), it's unlikely to cause a backfire out the carby (it would introduce false air and give you a fast/lean idle) ...sounds more like timing issues/spark plug wire routing responsible for the backfiring.    
×
×
  • Create New...