Jump to content
SAU Community

Recommended Posts

I went around to see an R34 gtr vpec today and the guy shows me the rego paper, it looked a bit suspicious because it only said nissan skyline. Nowhere did it say gtr or anything. Is this normal? GTR owners what does yours day. I still haven't ran a vin check which I'll go in the next few days, he's an alrite bloke but I dont want to end up with a melon. It has an rb26 but is it a genuine gtr?

Link to comment
https://www.sau.com.au/forums/topic/358502-r34-vin-and-rego-check/
Share on other sites

I went around to see an R34 gtr vpec today and the guy shows me the rego paper, it looked a bit suspicious because it only said nissan skyline. Nowhere did it say gtr or anything. Is this normal? GTR owners what does yours day. I still haven't ran a vin check which I'll go in the next few days, he's an alrite bloke but I dont want to end up with a melon. It has an rb26 but is it a genuine gtr?

My R32 GTR only says Skyline too. You will find that the "Model" designation is listed, not the badge. Pretty normal.

I owned 2 HSV Senators back in the 90's and their model designation stated Berlina as that was the core vehicle from Holden.

You reckon that didn't cause confusion from 1st time buyers.

Bob.

Ten Four the point isn't what it looks like, it's if it's genuine, you can make a GT-T look like a GT-R with enough money. I know the 4WD and etc are more hard work than worth it and is unlikely a conversion but I need to make sure.

Aussie_delivered is this the same for all the Skylines, I'm taking the car to an inspection anyway just to make sure it's genuine and it's not in bad shape.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...