Jump to content
SAU Community

Recommended Posts

Neighbour came knocking on the door tonight, says the lights on the car are doing weird things. I go out, and they are, rear lights and at the front, flashing between high beam and the fogs .... not bright, just dim like there's not much power. And there's not either, not enough power to open the doors by remote, or turn over the engine. So I've disconnected the battery, but now what?

I've looked at this post http://www.skylinesaustralia.com/forums/topic/343588-possessed-lights/page__p__5540346__hl__battery__fromsearch__1#entry5540346

but today has been one of the driest, sunniest days here in Melb for a long time, and there's not even a hint of moisture in the battery compartment. I didn't have the car today, my wife was using it, but it doesn't sound like she was doing anything unusual with it, certainly been no warning lights on recently.

I'm presuming it will go again with a jump start, once the RACV get here, but any ideas as to the cause? It's an '04 300GT sedan.

Cheers,

Richard

Link to comment
https://www.sau.com.au/forums/topic/359136-battery-dead-lights-flashing/
Share on other sites

new battery for a start. they are data driven and once teh battery diesthe CAN system goes into no mans land and has a freak out session.

start there and forget a jump start.

new battery for a start. they are data driven and once teh battery diesthe CAN system goes into no mans land and has a freak out session.

start there and forget a jump start.

Thanks Chris, will do.

Is battery death in these always that sudden, or should there have been other signs?

there is not a science to it.

IF you are lucky the car will be slow to start otherwise it will simply die. average life of a battery is 2-3 years at best. if in doubt - change it.

So when the car comes back to life it 'knows' where the windows are. You know that little automatic adjustment your car does when the door closes? Yeah you need to reset that.

Put window down, put window up and hold the up button for three seconds at the top, put the window back down. You should be good.

Just curious,

i changed my battery last week and read you needed to make sure the windows were all the way down before disconnecting...why?

So when the car comes back to life it 'knows' where the windows are. You know that little automatic adjustment your car does when the door closes? Yeah you need to reset that.

Put window down, put window up and hold the up button for three seconds at the top, put the window back down. You should be good.

So that process of "put window down, put window up and hold the up button for three seconds at the top, put the window back down" is after disconnecting and connecting it back?

So when the car comes back to life it 'knows' where the windows are. You know that little automatic adjustment your car does when the door closes? Yeah you need to reset that.

Put window down, put window up and hold the up button for three seconds at the top, put the window back down. You should be good.

Hmmm cant say i did that exact procedure,

but as far as i can tell windows go up/down fine and still do that lil kick at the end.

Well I got the RACV to jump start it this morning anyway. Seems like the fog lights had been switched on accidentally, which obviously did the battery draining trick. Guy said the battery was still very healthy, so I'll just leave it and keep an eye on it for now.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well some mostly good news and some slight bad news.  Good news is cylinder 6 did in fact only require a honing and I'm good to run my 86.5mm pistons again. I should also get the block back by end of week. Bad news, had a few surprises pop up. First, main and rod bearings were trashed. No sign of any heat damage. I knew right away what caused this... I had not packed my oil pump originally and spent a lot more time than I would have liked cranking the motor to get oil pressure. It sounded fine once started so I chucked it up to luck and forgot about it. Luckily rod and crank are fine and just need new bearings. Engine builder agreed that this was the cause.    Another surprise that carbon covered up very well that I didn't catch, something got sucked up and went through cylinder 1, 2 and 3. Luckily this was no cause for concern, just needed a bit of cleaning up. Valves look fine but he will vacuum test the head this week to confirm. I'm presuming this was something left over from welding my intercooler piping, but we'll never know. I'm going to thoroughly reclean everything.    So all in all, happy the motor is fine, and I'll get it back much sooner than expected. I'll also be taking the time to convert my WMI system over to direct port. I'll snap some pictures of that when the parts come in. 
    • I understand, thanks. Yeah I wouldn't want the car to tip over, I'll try and use the sills, I don't want to risk smashing the chassis rails. I ordered some rubber pucks that have a hopefully big enough slotting. If the front right gives me trouble I can always just make a wood block. I'll measure and inspect the sills closer once I actually take the car up. I hope so, but the rubber blocks I had in hand so far were pretty damn firm, if they are that hard they won't give much way. I'll let you know what happens. Angle grinding rubber isn't one of my favorite tasks. I'll probably start a build thread soon, for my own documentation and "log" as well as sharing what's going on with the car.
    • Kinda something I have been thinking about.  To be honest, we bought it already driving like that.  So there's no telling how long it actually has been driving like this.  Hopefully damage is too bad when we drop the pan.   I am having a hard time finding a site that sells the solenoid for the 5 speed auto, do you have any suggestions?
    • That'll be most likely down the road...  LOL  
    • a stock / option or aftermarket?
×
×
  • Create New...