Jump to content
SAU Community

Recommended Posts

hi there i recently did a rb26 engine conversion on my r34gtt with a r32 gtr moter and a apexi power fc d jetro

wen it got back from adelaide the car was flat and the airbag light wont stop flasing

is there any way to stop that as i thort that r32 gtr dident come out with airbags that i would not have them any more

Link to comment
https://www.sau.com.au/forums/topic/359321-rb26-conversion/
Share on other sites

theres a reset procedure:

1. Turn the key from off to on.

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

if that doesnt work theres another procedure for 33s that apparently works in 34s too.

Leave the drivers door open

Then turn ignition on so all dash lights are on but do not start engine.

When you have turned the key to that point press the drivers door interior light switch 7 times rapidly in succession,( within 7 seconds of turning ignition lights on)

Now the airbag light will flash at a different rate to before!

1 long flash followed by 2 short flashes ( the diagnostic system is now registering the fault in the airbag system)

Now turn the ignition off and close the door.

Now open the door again

Turn ignition on again until all dash lights are on but do not starting the Engine.

Now quickly press the drivers door interior light switch 7 times in rapid succession.

Now the air bag light SHOULD start flashing at a single rate ( the diagnostic system is now registering that the airbag circuit is now working correctly)

Turn the ignition off , and remove the key, now close the door.

Turn the ignition back on and the airbag light should go out after a few seconds.

Link to comment
https://www.sau.com.au/forums/topic/359321-rb26-conversion/#findComment-5739052
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...