Jump to content
SAU Community

Recommended Posts

Lads & Lass`es JDM run on this coming SUNDAY

Sunday, January 15, 2012 12:00pm until 4:00pm.

JDMWA's first event for 2012 will be held on the 15th of January, JDMWA #5 Photoshoot Meet/Cruise.

Meetup at 12pm meet for a 1.30pm cruise departure from Karrinyup Shopping Centre Upstairs Carpark.

Reason being for the longer meet is that we have had a lot requests to make the meets longer for more photos and time for people to have a walk around/come down for a look

afterwards iam heading to any BBQ in arear to have a feed so your call on what happens after,

Cheers Chuckie.

PS there is a few Stagea going so hope few may come along ,

  • Replies 482
  • Created
  • Last Reply

Top Posters In This Topic

also dose any1 know what rear rotors and pads fit a s1 stagea?

can get the rotors from duncan nissan for $140 each

and rear wheel bearings where can i get some? nissan was telling me that i have to get the full hub as well. there $300 each form nissan.

was going to front rotors and pads but thinking of changing it to r33gtst brakes

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • It was roughly 3.5 hours.    car went in around 11:00 and I was done around 2:30 He did the initial runs, install the BC and then Nistune install and tune.  The best part was sitting in the lobby and hearing the skyline on full throttle at the dyno 😂😂
    • Glad it all went smooth. How long did the tuning process take?
    • Yeah that was kind of the same feedback my tuner gave me.  the boost tee is until I can sort out my plan for the electronic boost controller and what I’d get, where I’d mount the dash etc.  I’m happy with this until I can figure it out. Not a big fan of the A-pillar gauges. I’d like to get a clean install of the boost gauge - something digital like GFB.  Something like that might fit neatly where the ashtray is and look clean. I feel like replacing the OEM triple gauge is a bit extreme for a weekender like my skyline. And it’s not making crazy power to need all the additional sensors/gauges. 
    • I'm about to swap my box to Tremec T56 Magnum F & initially thinking of re-using my DCS twin plate (can get it re centred for the bigger spline) but it's been called out the box will be noisy (rattle) as the clutch is unsprung.  So I'm doing as much research as possible. I'm not so worried about holding the power as I'll go the track version which on paper will hold the maybe 1000hp I make. It's the longevity I worry about. DCS told me they don't use a sprung centre as it's just something that can break. The uni clutch has a very complicated sprung centre. Any one had or heard about any issues with it failing? Thanks in advance.
    • Auto is at least 10% (from my real, actual experience with different torque converters and manual on the same setup) ~185rwkw at 11.6psi (peak!) is entirely what one would expect without a FMIC or anything else on the intake, it does bleed off towards the higher RPM so it's what, 9psi there? Note: There is nothing that can be done about this with a manual boost tee. If you want to hold it steady and gain more top end, well - You will need electronic boost control.....
×
×
  • Create New...