Jump to content
SAU Community

Central Coast Crusieing


Nissan Nutter
 Share

Recommended Posts

lol.. im hardly out in my car.. do i give them all 50 regos of work cars i might be driving..lol..

jez u still doing the asphalt work.. thought i saw ya missus mazda up near somersby falls when i was driving around a few weeks back.

have to catch up.. been way to long!

Still have fun memories of getting a lift to artarmon with u, when u had no speedo!!

Link to comment
Share on other sites

lol yeah been a while dude,

thats where i live at somersby, her zoom zoom is always here.

im heading to erina with Kimbo(missus) to get some dinner, then ill stop in at the kariong meet. starts at 830 i think.

might see you there so we can catch up

Link to comment
Share on other sites

Out the back of kariong info centre. A nice secluded location.

I havent yet but i am plannin on asking permission to use it for the thursday night meet ups.

Plenty of parking spots. No neighbours or shop fronts.

Just have to make sure everyone behaves.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share




  • Similar Content

  • Latest Posts

    • Installed  Nismo coppermix twin competition spec last year in my bnr32 with pull trans with Oem slave cylinder. The point at where the clutch disengages/enages is right at the top of the clutch pedal, meaning I barely have to push the pedal down for the clutch to be disengaged.  You guys that have the same combo are you experiencing this high pedal bite point??   Secondly I’d like to have the disengagement point lower meaning I have to push the pedal more(further not effort)for it to be disengaged.  I’m thinking to use a Nismo big operating cylinder(bigger bore at 13/16 vs Oem 3/4) which will require more pedal stroke to get the equivalent movement at the clutch fork. But I see Nismo web site says not to mix these 2 as the Nismo big operating cylinder doesn’t have enough stroke to disengage??? Any folks run both the coppermix twin pull with Nismo cylinder??    Thanks in advance for the replies but prefer only guys with pull clutches to respond. thanks     
    • Any chance u could let us know where your based ?
    • That’s a great deal and I would jump on it if you were closer. Melbourne is a bit of a hike for me though unfortunately 
    • I wonder if there is much to tell without knowing where the bolts where bought from. If it comes from Amazon or similar all bets are off. Can't trust them. And I fear not everybody knows that. Wasn't it @TurboTapin who ended up with the fake fuel lines recently? The submersible ones which very much weren't submersible at all. It kind of applies to everything nowadays. Doesn't matter if it's hardware or electronics. The fancy camera might have internals swapped out for cheap knockoffs. The hard drive will report a certain size but not actually be able to write it all. Shit like that. A bit depressing but the reality is you really have to be weary of where and how you buy stuff
×
×
  • Create New...