Selling 449Kw Setup

[grygtr]

The time has come to move on to a single turbo E85 setup, so im selling the following as a 449awkw package:

2x 2860-5 turbos(less that 3000ks COST $2750)+nitto gaskets(cost $220)+Stock custom match ported manifolds(5 hours @ $140 an hour of porting by local performance shop).

Rochester 1000cc Injectors cleaned and flow tested.(Paid $1000)

HKS split dumps(COST $900)

Trust -Greddy Suction Kit Skyline rb26 32 33 34 gtr( hard piped intake including filters cost about $1500)

Veilside 3.5" Y pipe Stainless (exhaust cost $3500) please note is only the Y pipe I am selling So 1/3 of the exhaust.

I would like sell this as a complete package for 4K. Dyno sheets availble to serious buyer.

This setup was running on a built 2.6 and was one of Australia's most powerfull low mount garrett setups.

As published in FF&R Car made 449kw at 26 psi and only ran this boost for JDM Fest dyno Comp. Car usually ran 21psi @390awkw.

All runs were completed on UtimateTunes Mainline chasis Dyno

Edited April 15, 2011 by grygtr

[grygtr]

I also forgot to mention I may split up if offers are good enough.

please PM any offers.

Edited April 16, 2011 by grygtr

[ea_5_spd]

how much?

[WHITER33GTS-T]

Its says above "I would like sell this as a complete package for 4K"

[Deano 1]

450kw from -5's..... wow.....

[grygtr]

Power pulled in front of about 150 people and FF&R @ JDM FEST

450kw from -5's..... wow.....

[dato$2nv]

what a/r are these -5's ?

[sycorb]

thats impressive im trying to get that with hks rs and its not happining

[grygtr]

Look at cams,cam timing, manifolds,tune,headwork....seriously the list goes on forever

thats impressive im trying to get that with hks rs and its not happining

Edited April 17, 2011 by grygtr

[gdzlar1]

pm sent man

[ido09s]

It is possible

We had these turbo's on the Bright Print race car on BP Ultimate making about 450rwkw. It wouldnt have been running any more than 24psi as we never liked running any more boost on pump fuel. We use to dyno that car on semi slicks as well which will always chew up a few kw. Was far from a standard head but it will do it. You just need someone who knows what they are doing with a dye grinder