Jump to content
SAU Community

Recommended Posts

Hi Guys

Sorry if this is in the wrong section, have been attempting to pull out the stereo in my GTR and after pulling out the rear bracing and supports ive found some wires that I can't Identify. The Blue wire that goes into a loom and a black plug that wasnt attached to anything.

Any help would be great

post-30696-0-12737500-1303015299_thumb.jpg

post-30696-0-50839300-1303015315_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/361208-help-identify-these-wires-please/
Share on other sites

bad photos can't count the pins, is it 11 pins or ? but I'd guess and only a guess a CD changer or external amp from the factory. depends on what radio it has in it or had in it in japan?????

if I can find my CD changer from my car I'll look at the plug which is a clarion or panasonic unit if I remember right

you could test each wire to see if it had power and what voltage you might find the plug on here maybe, but don't assume anything , if you pull up the rear seat or yank the gear surround to see if it comes up to the radio,

Pinout guide

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Latest round of updates on the car. I purchased and installed a SWS clutch slipper to help with 60ft times and got some second-hand good condition 275/40R17 Hoosier DR2 radials. Test and tune in November showed the tyres were an upgrade over my over 15 year old mickey Thompson's and I got a 1.8 second 60ft and pb et of 11.71 but even then, that run wasn't great due to rain and driver error (the event got called off 10 minutes later fast forward to the weekend just gone 25th of Jan and there was finally a break in the weather to let racing happen. The first run the track was slippery and only managed a 12.1@129 Second run the track was better and got a new pb et and mph: 11.54@131   Lith and I then worked out that I installed the previously mentioned clutch slipper incorrectly and its never been working, and I had just been dumping the clutch the entire time, we also noticed it was on street boost and not race boost. So I lined up for a third run with the car turned up in the first two gears, but the passengers side axle objected to clutch dumps and left the chat which stopped my weekend.   so there will be another attempt in the future once I replace the tyres as they rubbed and are stuffed now. but a low 11 should be on the cards.
    • Ceramic coating and heat shielding, you mean?
    • Turbos don't require pulling the motor apart so that's "easier". I would recommend the Nismo R3 turbos instead if you want to do stock twin turbo. It doesn't make as much power as the 2530s but it's only like ~50 whp off the mark and should have better response (ball bearing CHRA, slightly smaller turbo). A local that went with a Garrett G30 and 6boost manifold recently nearly burned his car to the ground after the hood insulator started melting and and burning so if you go single turbo I recommend doing a lot of research and validation work to make sure you don't do the same.
    • New rear lights, filler panel sprayed, cleaned and back together    before, during, after shots 😍
    • 100% is gyprock, I agree. Slip of the keyboard. Haha! I left my indicator bulbs out to save a bit of weight.
×
×
  • Create New...