Jump to content
SAU Community

Recommended Posts

bit more complicated then that.. it has been tried.. anything from japan is gonna be costly.. thats where matty is based.. and i can see smaoked reverse lights causing a defect issue..

$180 for front indicators to be tinted , aswell as a $1000 for tail lights? thats a terible amount of money to be spending on cosmetics. seriously just buy some black acrylic and also some clear. mix it to a ratio that you are happy with and just spray them your self. i did mine , definitly makes the car look more stealthy , as long as its a black car. why spend all that money ?

my 2 cents, cheers

na outside man , not inside lol. that wont work at all . outside is the visual you want to see , you arent going to be looking at whats inside. thats an alternative , those night shades.

but be careful because iv seen people use night shade on their cars , they are more of cheap look . looks kinds crappy in my opinion. thats why iv used black and clear , seams to look much better than that crap.. bare in my mind iv got a spray gun/compressor to do all that.

good luck.

Edited by sky017

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • As GTS mentioned, it takes a bit of faffing, some fiddling and a little modifying.  With the strainers, you can buy different styles. Some sit flat on the pump, some angle down.  Here are some photos of mine, ignore the ugly welds lol. 
    • The smart thing is to actually locate the pump at the right point down the hanger, so that the strainer can stay sticking out at a right angle, but near the bottom. This is the perpetual hassle with retrofitting any different pump to the factory hanger. Some just go where you need it to, some need fiddling and faffing, and modifying of stuff.
    • Some updates. After a lot of praying and some inspecting of crank threads, we've found that they were both kinda munted but nothing seemed terminal. The other option was drilling and helicoiling the crank. That is obviously the last option so we decided to at least try to get a OEM GM bolt in to GM Specs. So after honing/linishing the balancer from it's .002" interference fit to a .0018" to .0015" to .0013" it eventually slotted on to the crank. ATI state the interference is nominally 0.0007-0.0009... so it's still snugger than ATI reckon and explains the issues we had to fit the thing to begin with. New GM bolt went in at 37 ft/lb then torqued 140 degrees after which was EXTREMELY   but it tightened up to 140 degrees and it was a lot of force. So all things considered, the balancer is secured to the exact specs that GM want with the OEM Stretch bolt, (that ATI say you can use..) and the balancer itself is seated and snug AF. So WOO. Engine is now back in the car with lots of swearing. Bellhousing bolts done up, driver side manifold is on, AC Compressor and hard lines are back on the car. Next step will be to connect various engine bits/wiring/intake/radiator etc. Then oil and coolant and ... test start it? And of course, looking into this issue... which actually doesn't look so bad - It looks like it can be twisted back into shape with a set of multigrips. Anyone wanna buy my bonnet? Boy it looks good over there and sunk cost sucks.
    • Also this may be a stupid question, but how would you recommend getting the strainer on a downwards angle ? as they tend to obviously clip to the bottom of the pump which usually sits level 🥴
×
×
  • Create New...