Jump to content
SAU Community

Recommended Posts

JDM R35 2 1/2 years old

Tried to start it about 3 weeks ago, the battery was a bit low as I hadn't used the car for 2 months.

First it wouldn't start. all dash light on,

starter button nothing, but the headlights came on, and the headlight switch could not turn them off.

Then it finally started,but It wold stop.

Tried disconecting the battery, car still running, headlight still on, no way to stop it,apart from clamping a fuel line.

Tok it for a drive, after about 6 kms the headlights went off.

drove for 12 kms, stopped, and the starter switch stopped the car and it started again normally.

Everything operating as new again.

Tried to start it again yesterday, dash lights on, headlights on again, starter switch nothing.

Disconected the battery, dash light and headlight off.

So I charged the battery over night and tried again this morning, same thing again , dash and headlight on but it won't start.

Had to disconected the battery to turn the lights off.

Help Help any ideas all please???????

Link to comment
https://www.sau.com.au/forums/topic/362025-help-r35-gone-crazy-again/
Share on other sites

Thanks guys but it's not the battery.

Battery shows 12.9 volts plus tried a jump starter as well.

why are the headlight coming on?

Why wonldn't the engine turn off when it was running?

It must be to do with the can bus system somewhere.

might need a consult 3 to check it out.

Thanks guys but it's not the battery.

Battery shows 12.9 volts plus tried a jump starter as well.

why are the headlight coming on?

Why wonldn't the engine turn off when it was running?

It must be to do with the can bus system somewhere.

might need a consult 3 to check it out.

Batteries can show 14V and still be stuffed, especially after sitting around unused then quickly charged

Batteries can show 14V and still be stuffed, especially after sitting around unused then quickly charged

I agree but I have a multi meter on it and when I press the start button the voltage doesen't change, just silence.

OK the puzzle contunies

reconnect battery but first check current draw as it sparks a little as I connect and disconnect.

doors open interior light (door0 on close door? no windows up

reconect battry lower windows a bit close doors, check current draw .4 amps.

reconnect battery check for fault codes with cob

Troubleshoot reports "no codes"

ignition is on so I press the start button

this it goes off

Soooo try again and foot on brake MAGIC it start and press button again it stops

ALL fixed working perfectly again.

TILL NEXT TIME

this car is a worry

Thanks again Martin for trying

Jeff

Its not over yet.....(the trying)

Take the battery out of the car (disconnect it) for 5 minutes and reboot the CAN bus.

I have had it disconnected all night as I had it on charge.

still had the same "no start" problem.

and why do the headlight come on and won't turn off

It's all a mystery

You should Water Spray those brakes..... :)

Two things I would do -

Replace battery just for the fun of it - stop any stray noise potentially on the CAN bus.

Secondly drop the Steering Lock and lubricate the firing pin

I know none of this makes any sense - but give it a go :)

You should Water Spray those brakes..... :)

Two things I would do -

Replace battery just for the fun of it - stop any stray noise potentially on the CAN bus.

Secondly drop the Steering Lock and lubricate the firing pin

I know none of this makes any sense - but give it a go :)

they sound like long shots to me

but I repect your experience with these cars

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If doing that ^, I'd take the idle up valve out and plug the hole in the pump.
    • You can try capping the power steering idle up valve at both ends if it's old. The valve and the intake manifold. That is something that is known to fail in Toyotas with age and it will suck power steering fluid into the intake and burn it in the engine which can cause issues. Then bleed it again with engine off first. Do like 30+ lock to lock turns with the front wheels off the ground.
    • Hi Brent, I am wondering if you ever worked this out? I have upgraded this unit to a newer one and everything works bar the reverse camera, so i really want to know what plugs are what so I can patch the camera through. many thanks in advance Mike
    • Once you have to get up in the morning and be useful, you suddenly value sleep it turns out :p
    • Update:   smoke test all pipes no issues cleaned reservoir   fluid put in ( dexron 3 atf)   steering turn side to side and could hearing  gurgling from steering rack which I assumed was air lock, opened one of the steering rack connections and could see loads of air getting pushed out( not sure if you meant to do that / whether it will re introduce air into system)   anyways, loads of side to side sound was gone. Turned car on, pump was slightly ( barely) wining so turned side to side few more turns and fluid level when car on was almost none in resorvoir which I guess is normal if car is one. Turned car of and fluid was gushing out. Almost 200-300cc was pushed out. Repeated engine off side to side followed  by engine on and same result       going mad now. It seems system is either sucking air in whilst on or there is tons of air which I am not giving it enough time to bleed. Thoughts?   would it work like brake caliper if I open steering rack copper pipes and let gravity pull all air out?   or maybe have a restriction somewhere? What is the red circled item, could that be blocked? It i
×
×
  • Create New...