Jump to content
SAU Community

Recommended Posts

hey, i got a problem with my rb20det when you are about to come on full boost it starts missing and not running right, and from a stand still when u put the foot down it dose the same thing, starts missing, but if u ease the power on gently and stay under 3k it is happy and runs fine??? can anyone help

Link to comment
https://www.sau.com.au/forums/topic/362597-rb20det-missing-on-boost-help/
Share on other sites

In terms of checking them, somewhere dark/nighttime is best and you would normally see them arc out on to the engine....

Other than that do you run std boost? Checked/changed plugs recently?

hey, i got a problem with my rb20det when you are about to come on full boost it starts missing and not running right, and from a stand still when u put the foot down it dose the same thing, starts missing, but if u ease the power on gently and stay under 3k it is happy and runs fine??? can anyone help

also its really hard to start, like it takes 10 goes to get it running and when it fires it splutters for couple seconds then runs idles fine?

Edited by andyyyyyyyyyyyyyyyyy

check the spark plugs as well. pull them out, look at the colouring as well as get a feeler gauge to measure the gap. also inspect the coils for any signs or melting, etc (that's a sign they are arcing out). if they all seem fine then the issue may be fuel related and it might be worth putting the car on a dyno to get them to check the AFR's.

i put new plugs in today didnt change anything and coil packs look fine and i looked at them at night time and i didnt see anything arcing out.....

check the spark plugs as well. pull them out, look at the colouring as well as get a feeler gauge to measure the gap. also inspect the coils for any signs or melting, etc (that's a sign they are arcing out). if they all seem fine then the issue may be fuel related and it might be worth putting the car on a dyno to get them to check the AFR's.

i put new plugs in today didnt change anything and coil packs look fine and i looked at them at night time and i didnt see anything arcing out.....

Just thought, maybe you have the ignitor separate from the coils??? If yes that could be faulty.....

yeah the rb20 has a seperate ignitor and they do cause problems that are the same symptoms as dodgy coils. one major advantage is that if you have a mate with a rb20 or s1 rb25 then you can swap them over to try in just a few mins (much easier than swapping coils)

true, i just need a mate with a rb20 :D, so u also think it would be the coil packs that is making it not want to start straight away when its cold? takes a couple of gose to get it to fire up

yer fix it completely now i cleaned my AFM and it was covered in oil......

if that helped then it means that your coils are stuffed. new coils should make it a lot better.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yuck. But it's kinda the same principle, moving timing around to make car run bad but sound good.... I went for a more spirited tuning drive to iron out a few things. Car no longer stalls, and it loved to dip RPM low when you clutch in. After tuning this (and the 4-5 tables that HPTuners/LS1 OEM ECU wants for idle air correction) it's now behaving somewhat normal. All expected because there's a new TB, new Intake manifold and that new TB which is 102mm vs 78... has an entirely different IAC passage which is smaller because ????? Unfortunately at this point I went to make further fine tuning changes to avoid it flaring up, you know... _tuning_ the HPTuners dongle died. Well to be more accurate - The USB cable died in a fashion that anyone who has ever charged a phone will recognize. After the app demanding I resync it 50 or so times (which all 'succeeded' but all failed) the device does not want to sync and I've logged a ticket with support to see if it's fixable. US Support said it was a 'storage issue' but after removing the SD card inside it and formatting it/fixing it the issue does persist. Unfortunately usually the fix is "Turn in your old dongle and pay $700 for the upgraded one" it's cheaper because I get some free licence credits I unfortunately don't need. However I'm 10 minutes down the road from HP Tuners AUS/VCM so at least I won't need to post it, and logged a new ticket for support over here. Definitely drives different. My SOTP dyno believes it's probably making 310-320kw instead of the 280 before.  It scrambles for traction a little now whereas it previously different. It drives like a bigger cam car up top even though the cam is smaller, likely due to the cam not being advanced 6 degrees. The timing is deliberately low and the fuel is very rich so who knows if this will improve on the dyno. It may, imperceptably. Also funny is removing the pineapples definitely makes the car squat more and axle tramp less. So this behavior of having more top end, squatting more, and scrabbling for traction more makes me think = more power. But I could have just been sitting on the threshold of that kind of behavior before. Time will tell if my butt dyno is calibrated right. I need the exhaust leaks fixed before dyno tune for obvious AFR related reasons - I repositioned the pipes but I'm not confident it's fully sealed even if it is better. At least the car does drive around while I cannot tweak/tune it for now. And I have aircon again. medium success!
    • Don't use that manifold. Please don't use that manifold. Sunk cost fallacy is not worth the later pain. None of these will be relevant to the change that will come from the different turbo and manifold. As in, the effect of the exhaust will be nil, regardless of what else is changed. And all the cam and fuel system stuff is not changing either way, so has no effect. The turbo and manifold (and to a small extent the wastegate)....big change.
    • Just wanted to say thank you for your input   my man (lead mechanic by trade) and I have done a heap of work as you can imagine just to make the hot side work with the dump pipe, stupid massive intake on turbo, trying to get the waste gate on was not fun.  I’m kinda getting to the point where I don’t know if I try and make this work and not throw all this cash and time away or do I scrap the lot and start again? the Apexi I’ve got was tuned for a few slight differences:   Tomei pon cams (mine are stock neo) Turbo smart 38mm external waste gate (mines 45mm replumbed) with stainless screamer pipe  3inch turbo back exhaust with high flow cat Sard 800cc top feed injectors Sard adjustable fuel pressure reg    
    • Out here E90s are the cheapest way into a sporty-ish car because everyone knows just how expensive the repairs can get. 8-10k USD for an automatic 335i. 
    • Noted. Have noticed BMW are more 'high maintenance' for sure. They've attracted my attention as I think the used car prices seem reasonable vs other options, and the extra quality overall vs a commodore / camry / corolla or similar of the same vintage is appealing, especially the interior, and they are more on the sporty side whereas the others mentioned can be more cruising or economical A-to-B only.
×
×
  • Create New...