Where to get dyno'd in ACT??

[maxim]

Hey guys,

Im going to be down in Canberra for while and was wondering where the best place to get my car dynod at? Prices? Thanks

[Jay95R33]

G'day Maxim,

Depends on what you want to do on the dyno.

Did you just want to make one run and see what it does, or do you want to have a few runs and do some fault finding and/or tuning ?

I use AutoTech's dyno (well, only been there twice), the owner seems really interested in performance cars and is very enthusiastic about doing the work - he enjoys working on cars !!

His dyno seems to give realistic figures too, I've heard of another one in fyshwick that is about 25kw more !!! So I suppose if your just after big figures, don't go to AutoTech

Cost per hour is around $130-140 I think, but your best off ringing around and getting prices as they might do it for cheaper if you only want one run and no mucking around.

J

[maxim]

Hi Jay,

Thanks for the info!

I really only want to make a single run, pref with air/fuel stats for the run also. Just trying to get a figure before I add an electronic boost controller & SAFC. Then will probably need the full run/tune/run/tune type of thing.

Thanks for the recommendation, I'll get on to them on tuesday

[Jay95R33]

Cool,

Remeber that if your going to compare figures that you really should stick with one dyno for before/after results.

He also tunes SAFC's/PFC's etc...

Cheers

J

[maxim]

That would be good so he could do that to when the time comes.

Hate to sound stupid but it is a 'drive on' dyno right? (aka chassis dyno?)

[Jay95R33]

Yepp, that's it. No need to take your wheels off etc, you just drive straight onto it..

[maxim]

Cool, thanks for your help Jay! Have a good long weekend

[whytry]

there's jakes performamce in mitchell (rear wheel dyno only, but he has it in shootout mode which may read slightly more, but nearly all dyno's around australia are using shootout mode to get consistent results)

then there's ming in fyshwick (4wd, i think they are starting to use shootout mode as well)

and if you wanna impress you're friends and get a big reading (i know shouldn't say this) evo in fyshwick they have a hub dyno which reads ridiculously high.

also like jay has said autotech in fyshwick

prices range from 50-140 depending if you want one single run or a full report run that shows everything kw/torque/air fuel ratios etc.. it'll be more if you want to dyno/tune.