Jump to content
SAU Community

Recommended Posts

Disco; You're in Central Coast NSW right?

Come to the SAUNSW Motokhana next month, I'm sure GTRSean (R34 -9's) or someone else with a similar car wouldn't mind taking you for a quick run. There's a go to whoa aswel. Will cost you nothing, just bring helmet and normal motorsport clothing (Details in NSW EVENTS area). Ill have my RB30 with -5's there aswel if you want a ride in that.

EVO IX run more than 14psi, i can tell you that right now.

Upper RPM it drops off to around 14psi IIRC but it spikes deliberately to i think 17psi and falls back down to either 12 or 14

I'll find out next i talk to a mate who tunes em as its basically the first thing you fix - get boost holding and you get the extra 20-30rwkw, then exhaust etc and off you go.

its all in the evos short gearing.

20.creation.jpg44553433@N00.jpg

I think theres more to it that that and even though those 4G63Ts were originally from the heavier VR4 it went through lots of incremental changes between Evos 1-9 . Because it was aimed at restrictor based Rally homologation it didn't have to rev , past 5500 in Grp A trim , but it did need to make a lot of torque at what we'd consider low-medium revs . By the time the 6 came out the engine had been turned around and the turbo had the largest or 10.5cm twin scroll turbine housing and in RS and TME versions the titanium aluminide turbine wheel was available . From memory the TMEs actually had a slightly smaller compressor wheel than the GSRs 16G , I think it was called 15GK2 and where the GSR supposedly made peak torque at 3000 revs the 15G version made the same peak torque at 2750 revs and the same overall 276 Hp or 206Kw . Crunching the numbers gives 138 Hp/L or 103 Kw/L .

You get all sorts of differing opinions on part time and constant 4WD and my gut feeling is that having a "center" differential has advantages over an electrically controlled hydraulic wet clutch . Some say that the Merc developed 4 Matic system which I think Nissan based the GTRs on gives the RWD then AWD driving characteristics . I think it also means that the rears have to slip before the fronts starts to drive and the transitions may possibly be inconsistant . Mitsy also throws electronics in with the active yaw control or AYC rear diff . Personally I'd rather have had the 6RSs plate LSD because I think it would be more consistant as well as durable - and 15Kg lighter without the AYC pump and reservoir etc .

I had my 6 out earlier this evening and probably the nicest thing about its power delivery is that is so torquey even off boost - for a production 2L fourbanger . Its deceptive in that unless you boot it through the lower gears you don't get that welded to the seat feel but the part throttle stuff is very un two litre like .

For 16.5K I couldn't pass this car up and have zero regrets .

A .

Edited by discopotato03

Never own an ugly car.

The evo looks like something from an animated cartoon show compared to any of the rb skylines.

I couldnt give a fig if it held the bonneville record. Its ugly as a bucket of busted crabs.

Lol.. i used to think they looked quite alright and almost bought an evo 8 but bought a v35 skyline instead.. no regrets as the evo populated the roads so quick afterwards.. least i got another year or so out of the v35 before that became common as rat crap and i sold it.

My mechanic is always telling me the evo is a good car (and the amount you see going through his roller doors..frigging cockroaches). I do agree they are fantastic cars from factory and excel in many forms of motorsport well plus aren't too expensive to modify.. popular for a reason eeh.

Yes I agree Evos are not the prettiest things to look at but they do a good job of cooling a hard worked engine at sub light speeds . Its not easy to get good airflow through air water and oil coolers , particularly with a transverse engine , but Mitsy managed to do it well at least as far as the Grp A era went which was 99-2000 and evo 6 .

You do see Skylines with all kinds of extra cooling ducts in aftermarket air dams and bonnets and I guess beauty is in the eye of the beholder .

I'm a simply works broad minded person , I like what has function and function over looks suits me . You can't see it when driving it but your wallet will if its less than adequate .

Something I would like to know is the development path of the first GTRs as in was it a rehash of the R32 GTST coupe or was the GTST a re engineered toned down version .

I hear that Ralliart developed the Evos 4 5 6 first and then MHI toned everything down for the more mundane Lancer sedans of the era . To look all over my car its so different to a CE Lancer thats its hard to believe an Evo was a development of the CE . What I hear was that Mitsy was winning the international rally championships of the day and spent up big to stay on top - before WRC came along and killed production based race cars .

Yeah the later model Evo engines run MUCH more boost than 14psi. They have 14psi at max power but they run a nice fat 4 or 5 psi bump in the mid-range. The pre-remap dyno sheets of Evo X with just an exhaust run 23psi in the mid-range and under 11:1 AFR to keep it cool. The turbos that mitsubishi selected were an awesome bit of kit with a decent sized turbine.

The thing I like best about the Evo is the super quick steering rack - lovely. Definitely my GTST feels sluggish around the tight corner. But I like my torque and LOVE the rear slip angles you can make even on part throttle in 2nd and 3rd with a 2.5L and mild turbo upgrade.

Yep , I reckon a lot with the turbo was a reasonable sized turbine and significantly the 10.5cm twin scroll turbine housing . Later (Evo era) 4G63Ts seem to thrive on 17+ pounds of boost and people are always amazed to find that raising the static CR to 9-9.5 doesn't greatly affect this . What that does if give these engines more torque off boost and the ability to run warm cams without really losing anything down low .

As I mentioned there is a larger 10.8cm direct bolt on turbine housing available here and at the American Evolutionm site they're talking about an 11.5 one available . The Evo 10s one is larger again .

I'd like to try an Evo 9 turbo with the titanium aluminide turbine and the 10.8cm turbine housing because what you gain with the 33% lighter turbine you lose with the larger housing , in other words no loss in a higher flowing twin scroll turbine housing . Actually Forced Performance in the states has cast up a port shrouded bolt on compressor housing so that would help with high boost surge .

If anything the HKS bolt on ball bearing turbo appears to be the cracker , its sort of like a reverse rotation twin scroll medium trim GT3076R and the word on the street is that 350 ftlbs and 350 Hp at the treads is a cake walk . They call ia a "GT II 7460R" for 74mm compressor and 60mm turbine .

Yes the steering , its bliss though full lock could be better .

If I remember reading correctly autospeed or one of the those international publications had an EVO V going round the ring several seconds slower then then an R32 GT-R.

I've said before, the weight comment is not really warranted as anything after a 6 is either the same weight or heavier then a 32.

Beer Baron makes a good point that, "man all you have to do is X Y Z to an evo and you get so much power!!!" well like he says do "just X Y Z" to a GT-R are your looking at 250awkw ++

Evo comes with a more race oriented suspension setup from the factory, no two ways about it.

I don't know where I read it buy someone was talking mod for mod the Evo will be quicker then a GT-R in standard trim, which is pretty much bullshit, admittedly the evo guys will spend the cash they have left over on hookers and blow, whilst the GT-R fans among us are forced to sell ourselves on the street. Lol.

Comparing an EVO RS and a Standard GT-R is not fair as that is a race spec or rally spec compared with a Standard road car, Take a look at a comparison between an RS and an N1...

power potential is considerably less in an evo, especially livable power potential.

Disco is 100% right though in saying that the Evo as a near standard thing is a very good bit of kit and yes, alot cheaper and bang for your buck then a GT-R but I would not include "faster" in that sentence.

As far as launching and taking off, the close ratio of the evo ( for the first three cogs anyway) is awesome, this coupled with the sharp steering rack and the firm suspension make for a very fun and fast car.

But not much launches as hard as a GT-R especially on street tyres, Just ask Duncan.

Disco what gains would you expect from the 10.8cm housing change to an Evo9 turbo? A good friend of mine is near the limit of this std turbo Evo IX and was thinking of GT3071 upgrade. Obviously the HKS turbo is between the 3071 and 3076 but a housing swap might be better BFYB.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seemed to be good when Jeff owned it but they did a shit job on my car, probably worth a think before spending 10's of thousands of dollars where they might be cutting corners
    • Starting with issues 1 - 5, we have already run into a problem...!  Issue #4 contained 2x front brake calipers, instead of 1 caliper and 1x steering knuckle. Will have to call DeAgostini on Monday to sort it out. Anyway here's some photos.  Issue #1 is the front bumper, headlights and number plate. Issue #2 is the front wheel (with "We produced with spartan air." text on the centre cap!) and tyre, the front lip spoiler and cylinder head cover with ignition coils under the centre cover... which will never be seen again. Issue #3 is the bonnet and cylinder head. Issue #4 is the front strut, brake disc (with laser etched metal discs) and brake caliper. I stopped here because of the issue with the missing steering knuckle.  Next update will be #5 - #10 in a few weeks.
    • DeAgostini is one of a few companies that release quite large (the largest commonly available size actually) 1/8 scale models in a series of weekly issues over 100 - 110 instalments.  They release different models for different markets and DeAgostini Japan have release the BNR32 Skyline GT-R Nismo last month. I've made two of these 1/8 scale sized cars (one an R35 GT-R from 2012 - 2014, the other I'm just about halfway through, a BNR34 Skyline GT-R from the 2Fast 2Furious movie) so when this R32 was announced there was no way I could ignore it as it's my favourite out of all Nissans.  Each issue costs around $20 so it costs about $2.2K when completed. I suppose it is very expensive for what it is, but the quality and details are really very good, and there are many "gimmicks" like fully functioning exterior and interior lights operated with a remote control, working steering, all doors/bonnet/boot/fuel lid open and close, the side mirrors fold in and it even has a speaker for the engine revving sounds when you turn the lights on.  Each issue comes with a magazine that tells the story of the BNR32 Skyline GT-R Nismo from the first design stages of the BNR32 to Group A homologation and the various racing version that were run in the Japanese Group A and JGTC, and Australian Group A.  So I plan to update the build in this thread 5 issues at a time.  https://deagostini.jp/r32/?srsltid=AfmBOooKjxDc4EUK2rmXqMBPgyHfFJ24s4oEPJBNpnF-lFlsRoW0PE6P
    • As per title.. has anyone used so far? Keen to hear results, comparisons. In the market for a new mani for my new turbo. Any issues cracking?
    • Re read everything that has been written about this in this thread.. Let us know if you're still confused.
×
×
  • Create New...