Jump to content
SAU Community

S A: ++ W R E C K I N G -- R 3 3 ++

nisskid
 Share

Recommended Posts

nisskid Grand Master

nisskid

Posted
Posted

Wrecking everything from an R33, some of the stuff is already gone, but post up in here what you're after and i'll PM you if i have it.

few key bits:

Engine (minus injectors, turbo and ecu) - $1500

Turbo - HKS 25/30 - $900

Gearbox - SOLD

Suspension is complete, so pretty much everything from there is available at this point.

Also looking for someone who wants to take the shell, it has sustained damage at the front corner, the radiator support has been moved at the top (ok at the bottom, but needs to be replaced), all the suspension and arms looks ok, the strut tower hasnt been moved, the chassis rails are fine. Is a economic write off, so no rego til it goes through inspection

Rolling w/interior - $1300

Rolling no interior - $1000

Not rolling, no interior - $500

prices aren't with brakes, that will be extra.

Located near Mitcham in SA, but can post most parts anywhere.

Link to comment
https://www.sau.com.au/forums/topic/364944-s-a-w-r-e-c-k-i-n-g-r-3-3/
Share on other sites
  • 4 weeks later...
nisskid Grand Master

nisskid

Posted
  • Author
Posted

hey guys, suspension has been taken out, turbo sold.

also engine has a separate thread now:

http://www.skylinesaustralia.com/forums/topic/367649-s-a-r-b-2-5-engine/page__p__5864338__fromsearch__1#entry5864338

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • GTSBoy
      Skyline r34 gtt tie rod

      By GTSBoy · Posted

      Yes, an R34 workshop manual is downloadable. The R32 GTR one which is findable everywhere would also do the job, seeing as almost all those bolts are same-same enough.
    • Duncan
      Eibach wheel spacer

      By Duncan · Posted

      It can be hit and miss, I can fit 15mm ones on the v37, but only because the wheel happens to have voids on the mounting face that allow it to fit. Have you checked the mounting face of the wheel and know it will not sit flush? Rather than cut (or try and find shorter) studs, just buy a thicker spacer (unless clearance from the wheel to the guard does not allow it), then everything is reversible in future
    • GTSBoy
      Eibach wheel spacer

      By GTSBoy · Posted

      Obviously you need shorter studs (don't just cut the original studs off!) and really short nuts that will fit in the spacer. Thus exposing the problems with thinner bolt on spacers.
    • The Bogan
      2002 VX SS Commodore $30,000 ono

      By The Bogan · Posted

      https://www.carsales.com.au/cars/details/2002-holden-commodore-ss-vx-ii-auto/SSE-AD-18219062/?gts=SSE-AD-18219062&gtssaleid=SSE-AD-18219062&pageSource=details
    • drifter17a
      Skyline r34 gtt tie rod

      By drifter17a · Posted

      does anyone know tie rod torque setting and anti roll bar for r34? Is there a workshop which shows various components torque setting?
×
×
  • Create New...