Jump to content
SAU Community

Recommended Posts

Ok, im having trouble with my car. it started out as just a flat spot in 2nd, but now its become a total loss of power right through the gears and into full boost. when it idles now it's like a misfire, the revs are jerky and the exhaust note is off. i ran the ECU diagnosis test, and it came up emtpy (55). i checked all the coil packs, and none of them seam faulty. i suspect it could be bodgy spark plugs or maybe a fuel pump fault, or a crank angle... im really stumped here. the car is running like poo and it only started stuffing up about 2 days ago. any help or suggestions appreciated.

Edit: It's an R33 Series 1 93 model with 130,000km on the clock

Link to comment
https://www.sau.com.au/forums/topic/36550-flat-spotpower-loss/
Share on other sites

Well, actually i had a squealing noise coming from somewhere whenever i hit 5000rpm, full boost, but it went away once the car was warm. i went around all my intercooler piping with a spanner and gave all the clamps a tighten, then the noise stopped. after that was when the flat spot occured.

Well the self diagnosis didn't say anything was wrong with the turbo. also, once i get into the higher revs it runs normally, i'd assume if the turbo was dying that at higher revs/boost it would run even worse.

3 things I can guess at..

1.) spark plug gap is too big. try re-gapping them to 0.8mm

2.) AFM is dirty and neesd cleaning or there is a leak between the afm and the throttle body. You said you already checked the cooler piping but what about the induction pipe from the afm to the turbo..?

3.) bolts on the turbo manifold have come loose causing you to loose boost through there before it gets in to the exhaust side of the turbo. If this is the case, it will soon blow the turbo gasket requiring a new one (which is about $20) but putting it on is a pain in the arse and will cost about $150 for a professional to do.

hope that helps.

TT

I think your coil packs are on their way out. Mine was similar to this when it started happening and the people I bought the car from said they would fix it for me. They tried everything but the coilpacks even though I said that's what I thought it was.

Eventually they did it; zoom zoom.

If this is what it is they will get progressively worse over a month or two. The ECU can only see one side of the coil packs so it can be them without an error code.

Check your crank angle sensor too.

Ok, i started pulling the coil packs out to replace the spark plugs, and they're wet. not wet with fuel, but wet with water?? i cleaned the engine bay the other day with a damp sponge and then splashed it with water, but i couldn't imagine water getting into the engine. this i asume is not a good thing, so ill let them dry.

i checked the coil packs, it wasn't them, they're fine. the turbo gasket thing is a possiblity. i might have a go at that next if replacing the sparkies with 0.8mm gap ones doesnt do anything.

thanks a lot for your help, really appreciate it.

Ok, replacing the sparkies didn't change anything. it still has a massive flat spot when i rev it, then it's idle is really surging. is there any chance it could be the injectors are dirty?

when i rev it and there's no exhaust noise, i can hear an odd spinning sound. im assuming that's the turbo spinning without any exhaust hitting it. im stumped, but i don't want to have to resort to a mechanic

If you have been cleaning your engine bay lately I would be checking the electrical conectors on the AFM, O2 sensor, CAS and ignitor for damp conections.

Check for coil packs for earth leaks aswell, as the insulation on the coil packs becomes brittle from heat and breaks off causing stray discharge.

MEGA

That surging points me away from coil packs but I'd just like to point out that my coils showed no signs deterioration or earthing and tested fine but when they were replaced the problem was fixed.

Not trying to tell you over the internet what to do, just making sure that you and anyone reading this realises that this is a possibility.

Good luck with it mate, and let us know what fixes it.

How do i do a fuel pressure test? i'm a bit of a newbie at skylines.

also, might a power transistor fault have the same effect? a mate of mine seemed to think my dizzy was on the way out, but not knowing i don't have one.

the problem seems to have stopped getting worse. i just have a lack of power sometimes, my idle is rough and when its cold it won't rev past about 3000rpm and sounds like its running lean or not getting fuel or spark.

I have another theory.

is it a common, or likely occurance that the timing gears/cam gears can come loose, or the timing get wacked out some way, maybe a tooth on the timing belt has come off or the belt has jumped a tooth? i had my head in the engine bay and there were odd noises coming from under the cam cover, and also a spinning/wooshing noise coming from the inlet manifold.

anywho, any replies are appreciated.

hate 2 tell ya that washing your engine bay is very bad and a costly mistake. i learnt the hard way.

First all the coils are warpped and will not fire properly.

all your plugs are damaged due to the water.

you need need all new coils and plugs to fix the problem and they are not cheap!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • They see me rollin' they hatin'....... Took me most of the day to make the necessary mods to the mounts to make them fit the car.  Fortunately I was able to just use the mounts that came with the rotisserie. The rear ones are really secure, the front I feel i might reinforce a bit more as it doesn't seem like enough attachment to the vehicle. I'm sure it's fine but better to be safe than (extremely...) sorry.  I drilled and tapped thread into additional M12 holes to each car mount where it attaches to the rotisserie as an extra fail-safe. Without them the side to side movement is just restricted by the allen head pinch bolts, nothing actually goes though the beam. Does now! I still need to adjust the rotisserie to get the car centred in terms of centre of gravity. If it's too high or too low relative to the rotational centre line of the car, it will be like a turtle and roll onto its back or as it currently sits, I dont think I'd be able to rotate it as it sits as it needs to lift the whole car up as it rotates. Ain't happening... I'm going to be nervous as hell the first time I go to spin it on its side...    
    • Oh yes done this when the window started flopping around.  Turns out the guides that run along the rail chanel had crumbed way. Took off the door card and pulled out the window mech, then the window, which you have to pull out through the top. As said unbolt the guide rail and don't spend 30 minutes getting frustrated trying to find a way to slide it out upwards cause that don't frigging work. Drop it down and out through the door hole. All I did to repair it was slice some 10mm clear plastic tube, vertically, then screw it to the guide rail both sides. This tubing rolls inward on both sides and leaves a gap wide enough to hold the window. To finish all I did was lube the plastic tube with olive oil and Bob's your uncle . . . well if he has the operation he can be your Aunt ! !  10 bucks in plastic tube and another 5 minute job done again . . . . YEH BULLSH#T ! My love for Skylines knows no bounds !
    • So was there a solution to this problem? I’m having this issue now. 
    • not expensive, just irreplaceable if you don't go sub 60 at wakie in that thing people will start talking
    • I haven't replaced that, but I have had the doors apart on the r32 a couple of times The door skin will be held on by a combination of clips and bolts, just take it slowly and make sure all the sneaky hidden bolts are out Once the skin is off you should be able to pop that piece off pretty easily, looks like there are only 2 bolts holding it on
×
×
  • Create New...