Jump to content
SAU Community

Recommended Posts

Looking at getting some Porsche Carrera cup front slicks on the GTR, but was wondering what kind of effect would it have on a non uprated sump. As I know it, mine is standard so the last thing I want to do is destroy the engine from an oil surge. A couple of track here in the UK I would avoid as they have have fast corners that go on for more than 4 seconds..

I have been hearing a few things of dry sump setup for an RB, but have not seen much about the kit itself or the costs.

Dry sump is ideal but megabucks (google for examples) . You can get a bigger sump with gates and baffles and for the Link/Vipec and possibly other ecus you can get an oil pressure cut out switch to cut the engine when oil pressure is inadequate for the rev range.

nb I hope you are going to get 4 slicks and not just 2

Do you have the suspension adjustment to make use of the slicks?

They aren't like normal semi comps or street tyres. If you have a stock sump im guessing you might not have such adjustments.

There is a thread in the Motorsport section about slicks, have a read of it.

Ah i was talking thing like camber etc, you need MUCH more than you would run on the street.

Have a read of the MSport section, you really won't get much benefit of slicks by the sounds of your setup and would be far better off with semi's.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • FWIW the depth of the groove in the rubber pad is not super essential, the blocks are rubber and squish a bit. If you are worried an angle grinder will make a deeper groove quick smart
    • I mean, if you were to move the jacking points away from the original location, that is, away from the wheels and closer to the centreline of the car, then it will be more likely to overbalance and tip off the supports. Same as we talked about before. I was talking about moving for-aft. If the sill is bent outward or inward, then the car would obviously look unstraight from the outside. Hopefully that hasn't happened either. Again, you can do comparative measurements from the chassis rails to see if there is much deflection.
    • Can you elaborate what you mean with your first sentence? I meant move as in the bulge kinda seemed like it got pulled "outward" meaning it got pulled down and to the side with the jacking rail itself, so the load bearing bulge now sits lower than usual and is not level with the sill on the other side of the jack point. Either that or the jacking rail just got pushed in a good bit.
    • As well as being risky WRT tipping off anyway. Yeah, I wouldn't expect it to move. Just measure from the rear one to the front one on the good side, then measure that same length on the wrecked side. You will find the notches in the pinchweld, and the jacking pad. Just spray a spot of marker paint or something there.
    • but any other area than the bulge you are talking about will just cave in then? The front driver side is pretty bent so I don't know if that will work the way it is now. I can still kinda make out where that bulge is/was but it looks like the position of it also changed due to all the mistreatment? Hard to tell
×
×
  • Create New...