Jump to content
SAU Community

Recommended Posts

HOOOOOOLY POOP THAT LOOKS GOOD

i wanna be in on the next one if i have cashhhhhh

and crapppp I have e-tag bracket on the skyline :/

And I'll come along to help you and Matt out (by deftly putting a "fly" in some conspicuous spot - guaranteed to not come off at that speed) :P

  • Replies 192
  • Created
  • Last Reply

Top Posters In This Topic

I'll get to them... eventually. Pretty busy over the next couple weeks (non photo busy for a change) I think I'll just pop them in here, since this is where most people who went know to look for them.

I wrote up a bit of a blog on the shoot nights, and have added all the finished shots in one place on one page.

do check it.

RIG BLOG

looks pimp in that pic jez!!! now its time to buy shares in the nissan Nur spec code code, cause half of australia is about to paint there 32 gtrs that colour after they start seeing pics of it. hehehehe

I was dizzy with power when i was standing on that trailer! king of the world I was!

here's the rest of the Jez mobile.

5965768883_a5ce6437e3_b.jpg

5966325460_2c950dd1d7_b.jpg

5966326124_008a8fba18_b.jpg

5966326690_6f3ef90bb8_b.jpg

I'm almost happy with how they've turned out. A different location, and not shooting at lunch would have helped out enourmously. but let's not get in to that on a public forum :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Bit of a similar question, apprently with epoxy primer you can just sand the panel to 240 grit then apply it and put body filler on top. So does that basically mean you almost never have to go to bare metal for simple dents?
    • Good to hear. Hopefully you're happy enough not to notice when driving and just enjoy yourself.
    • I mean, most of us just love cars. Doesnt necessarily have to be a skyline.
    • Did you pick up a manual cluster to remove the position indicator?  (Pretty sure the 34 has the gear position in the cluster, but it's been a while)
    • Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
×
×
  • Create New...