Condensation In Headlight - M35

[impul535w]

Hey Guys,

Anyone else suffer from this problem?

Solutions?

Cheers, Mike.

[Sunkist]

not sealing properly..

sickaflex the surround outside the headlight, take the back off and allow the inside to dry.

re install.. try not to get water on it for about a day..

either that or pull them apart and start from scratch resealing them..

paint the insides black too

[Dunc]

Hey Guys,

Anyone else suffer from this problem?

Solutions?

Cheers, Mike.

I assume you guys have checked the obvious things, ie the oring on the back is in tact & it is completely sealing when you close it up?

[zei20l]

had the same problem, Dunc is on the money, the rear access panel wasnt sealed up properly

[impul535w]

had the same problem, Dunc is on the money, the rear access panel wasnt sealed up properly

I think they are on properly, I don't know if I'm special or what but they were a real pain in the ass to get back on after i replaced some globes, is there a trick to it?

I noticed there is an arrow on the covers but do they line up with anything, couldn't see if they did...

Mike.

[iamhe77]

Arrows should be in the 12 o'clock position when done up.

Just make sure the tabs lined up with the cut away sections properly (it should be damn tight when you turn it)