Diff Housing For R32

[richoiftnfs]

Can any1 tell me from experience if any diff housings from silvias will fit in2 my r32 gtst subframe and if so what models?

[turboedsloth]

S13 diffs bolt straight in, they either come with 3x2 or 5x1 half shaft bolt configuration, these can be just swapped over to suit your car

[jiffo]

  On 26/06/2011 at 7:57 PM, turboedsloth said:

S13 diffs bolt straight in, they either come with 3x2 or 5x1 half shaft bolt configuration, these can be just swapped over to suit your car

Also might have to swap the back covers across and check for ABS. (long or short pinion nose)

[richoiftnfs]

Would a shimmed s13 diff centre fit into a r32 diff housing or do u have to use the s13 housing?

[turboedsloth]

It should do, pull the backs off both diffs and measure the diff centre to make 100% sure they are they same. The diff in my 32 is out of my old S13, bolted straight in just had to change teh half shafts. Both were non-abs

[-Jimmy-]

I bolted a diff out of a 180SX straight into my R32.

[bubba]

The housing and centre in my 32 are from an S13, bolted my 32gtst Nismo 2-way centre in no worries, just used the 32 backing plate.

Axle differences have been mentioned, only other thing is don't mix and match pinions/crown wheels.

[richoiftnfs]

Thanks for the help and advice guys