Jump to content
SAU Community

Recommended Posts

I seem to be having the same problem, except more intermittent.

Car threw a code on the dyno for TPS, without completely killing the throttle.

I didn't have great throttle response afterwards, but the throttle _always_ worked.

We cleared the code, throttle response was better.

Now twice in the last few days it has suddenly lost all throttle response, just idles. This wasn't on WOT or taking off, just normal street/highway driving. I pull up ASAP, turn the car off, turn it immediately back on, and throttle is fine.

No code clearing, no mucking about: Goes bad, turn off, turn back on, goes good.

I think it could be one of four things:

  1. TPS sensor - most sensible thing given that's the code it threw
  2. Cruise control, which has a T piece in the throttle - both times it's happened so far I've had the cruise control on and I've either been using cruise or just turned it off
  3. F-con throttle map
  4. Throttle wire on the ECU, where I had to splice in the wiring for the EVC

None make sense to me given the weird behaviour. I'm thinking of disconnecting the throttle T-piece for the cruise and seeing how it goes. If it continues, replace the TPS sensor.

Anyone else noticed anything similar?

I had to disconnect a cruise the other day for the same fault, I have also seen the throttle assembly being the issue. (tps)

Mine did the same thing with the pivot throttle controller plugged in, any resistance difference between the two throttle signals will trigger limp mode.

Try disconnecting the cruise for a while, it may well be the answer.

I seem to be having the same problem, except more intermittent.

Car threw a code on the dyno for TPS, without completely killing the throttle.

I didn't have great throttle response afterwards, but the throttle _always_ worked.

We cleared the code, throttle response was better.

Now twice in the last few days it has suddenly lost all throttle response, just idles. This wasn't on WOT or taking off, just normal street/highway driving. I pull up ASAP, turn the car off, turn it immediately back on, and throttle is fine.

No code clearing, no mucking about: Goes bad, turn off, turn back on, goes good.

I think it could be one of four things:

  1. TPS sensor - most sensible thing given that's the code it threw
  2. Cruise control, which has a T piece in the throttle - both times it's happened so far I've had the cruise control on and I've either been using cruise or just turned it off
  3. F-con throttle map
  4. Throttle wire on the ECU, where I had to splice in the wiring for the EVC

None make sense to me given the weird behaviour. I'm thinking of disconnecting the throttle T-piece for the cruise and seeing how it goes. If it continues, replace the TPS sensor.

Anyone else noticed anything similar?

I have just had this happen on mine too, throttle hasn't failed, but response is really lazy below 3000 rpm, with basically no boost.

I actually thought it might've been a camshaft position sensor.

Reset once, was fine for a couple of days, then lazy again. Reset, but noted the code, which was 1705; throttle body.

I'm running cruise control also, but I have been for well over a year now with no issue. I don't think that's the issue.

Going to have a poke around tomorrow, check plug & pins are clean & plugged in; but I would think the next step is a spare known tb to see whether it returns.

I'd be interested to hear what you come up with Ryan.

Cheers guys.

I'm with you Dale, don't think it is cruise control. Doesn't make sense after a year of fault free running.

On the other hand it is the easiest thing to test, and of Scotty thinks it could be a signal problem I'll give it a try.

Just weird the problem didn't appear until the fcon went in...

After another look at the fault code listing, mine is actually; P1705 Throttle Position Sensor Circuit A/T

This could also explain why mine didn't want to kick down, or unlock the converter with a small throttle input.

I might be looking elsewhere...

After another look at the fault code listing, mine is actually; P1705 Throttle Position Sensor Circuit A/T

This could also explain why mine didn't want to kick down, or unlock the converter with a small throttle input.

I might be looking elsewhere...

Easiest thing is to replace the sensor though, or that's what my thought was...

You've had some stuff going on with your car lately, hey Ryan.

I also don't think it's the cruise as mine hasn't given me that problem either (although I don't drive it much ;) ), but like you say - it's easy to rule out as it only takes a minute to unplug the throttle harness.

If the fault appears semi-regularly now, it shouldn't be long before you know. Hopefully it's not the F-Con but a TPS as that's means the F-Con is OK (as the last 'electrical' mod you've done it has to be high on the list of possibilities). It could also be the cruise control interacting badly with the F-Con, but I don't know anything about how they wire in so just throwing it out there...

The timing of the fault is a bit of a coincidence with the F-Con going in though, & I have a hard time believing coincidences, so good luck with the fault finding.

I have Leon, although most are my own doing so can't entirely blame Mr Nissan.

I find it hard to believe it would be the F-con, but like you said it is one of the last electrical mods. Scotty has been running the F-con with the cruise for a while now without issue, and I also find it hard to believe it'd be the mapping for the throttle in the F-con if the throttle completely dies.

They wire in by plugging in between the ECU plug and the ECU, entirely piggy back, except for a MAP and IAT sensor harness in my case.

dale, I have a spare TB and pedal sensor if you want to try them on your car for a few weeks

Thanks Iain! I'm going to see if it comes back this week, and I'll be in touch.

I still have to get the name of the shade sail place for you too.

Cheers, Dale.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Son, in this country, that is a piece of Gyprock. f**king drywall. FFS! I also like the autocorrect of trailer to tablet. I was reading it and thing, "what the hell drugs is he on?" Then the photo made it clear enough.
    • SO whats the deal with this issue? I've read a heap of posts from the infinity owners in the US having full engine swaps done under warranty. Most claims are done on earlier cars than 2019 but I'm sure I've come across claims of 2020 models also having this issue. I like the 400r and Q50Red/S but can't fathom dumping close to 50k on a car with terminal issues!!! 
    • The above video is working normally. That is, that's how the right hand indicator should cancel when rotating the wheel left.
    • I noticed that I could see creatures on the moon when I turned my new headlights on. I thought I should check the alignment. It's pretty rudimentary but I just grabbed some dry wall and put it against my tablet and made sure the beam was below the height on the headlights. Ie the beam is at 600mm on my car, I just made it lower than that 7.5m away.  Not the best but it'll do until I can do it properly at the local shops.   
    • As @Duncan said - the bores are most likely to cop it. But anything can and does happen. Rods are cheap. Rods are good. The work to rebuild the motor will be 30x the price of rods. You won't notice it.
×
×
  • Create New...