Jump to content
SAU Community

Recommended Posts

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

Cluster comes with 147Km on odo. Just goes to show how far wound back most cars are that are sold here (assuming fairly typical distance travelled). Having said that, I don't particularly want my car having an extra 50K added to the odometer. Then you got to explain to everyone who looks at it... lol

well your probably aware that 87-90 degrees of water is normal for our car.

its just how thin the radiator is and the load on it.

bigger radiator to take the load for winter will far out do the thermostat, especially if it ends up being too cold and keeps the car is a cold start map lol

Don't confuse the Nismo thermostat (which doesn't do that) with the Mishimoto thermostat (which does do that).

Bigger radiator would be more beneficial in the summer you'd think, yes?

Don't confuse the Nismo thermostat (which doesn't do that) with the Mishimoto thermostat (which does do that).

Bigger radiator would be more beneficial in the summer you'd think, yes?

yeh but there is a lower temp nismo thermostat available. isnt there?

i duno what your trying to get at

I thought Nismo was lower than stock, and Mishimoto was lower again.

Thought I read a thread on here where Scott fitted the Mishimoto and it was too cold and stuffed the car around, but I haven't seen much on the Nismo?

I run a 54mm race radiator and the Nismo thermostat.......no problems with my car with normal running in winter.....it hangs around 85 to 89 in traffic and about 84 on the freeway on hot or cold days....pretty sure from memory it was the same in summer.

On the track it dropped down 2 degrees and ran a perfect 83 degrees the whole time.......makes me think that it would do about 85-86 degree's in summer on the track!

Edited by Jetwreck

I run a 54mm race radiator and the Nismo thermostat.......no problems with my car with normal running in winter.....it hangs around 85 to 89 in traffic and about 84 on the freeway on hot or cold days....pretty sure from memory it was the same in summer.

On the track it dropped down 2 degrees and ran a perfect 83 degrees the whole time.......makes me think that it would do about 85-86 degree's in summer on the track!

Ahh too late sold it to Whiteaxis...LOL

yeh but there is a lower temp nismo thermostat available. isnt there?

i duno what your trying to get at

Below would be what I am getting at, thanks Ryan.

I thought Nismo was lower than stock, and Mishimoto was lower again.

Thought I read a thread on here where Scott fitted the Mishimoto and it was too cold and stuffed the car around, but I haven't seen much on the Nismo?

You don't really hear anything about them because the Nismo just works.

no you can legally change them over and report the change, to be honest i dont know whats involved. mine was only a few thousand off so i didnt bother

Mine has 25,000k's on the odo now. ;) I still have the original I can give the next buyer but I don't think they will care. Its obvious an aftermarket Nismo dash will change the K's isnt it?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep it's an r34. Usually people remove struts without removing the front upper control arm (fuca is what i assume this is?) So not sure why mine wouldn't fit. I know on my other car I did a similar job and it wouldn't fit until I removes the ball joint nut even though I didn't remove it prior.   The upper arm doesn't seem to be in the way (the part that's bolted to the chassis. The part that's bolted onto the j arm I'll check that out though.   I was going to compress the spring and put it in with the compressor attached but not sure if it will work  Haven't seen anyone do it.
    • I have a small lip on the boot of the E90 and I've been toying with the idea of trying to mould it in to the boot to remove the gaps. I guess shaving the seams? No idea what the terminology is here.  What I'm wondering is, if it's current double sided taped down, what would I do to more permanently attach it so it makes a good base for the filler? It only has edges so no way to bolt it down unless I add some braces. I've done a lot of fibre glassing in my time so that's nice and easy but I'm not sure what my options are here.  Sorry, this is the best pic I have and I'm 4 million ks from home ATM.  
    • Based on this comment I went googling. A052's in the sizes I want are certainly not cheap, but I couldn't find anything in the V70A anywhere. How much do they run/where do they get sourced from? From what I know (nothing but internet searches and reviews etc) the R888 has pretty much fallen off from anyone's actual use, and the AO52 is the king of "road legal" rubber. Nobody is driving around on their daily for Z221, AO050, DZ03G. At that point, for purely track only tyres - Why not buy actual slicks? Why does nobody actually do that anyway?
    • This an R34? It shouldn't matter though - it should be the same as on any of the others, and by "any of the others" I mean R32, because that is the car that I have had the front end apart on about 50 times this year. Sometimes, it is much easier to get the lower shock eye onto that pin when: a) you have the upper shock nuts backed off a few turns so you can wiggle it a bit more freely. When they are tight the bottom of the strut is much harder to move that _leeeetle_ bit you might need it to to win the fight. b) you have the outer bolt(s) from the FUCA out and so you can move the lower pin around freely too. Then, all you have to do is put the upper arm back on when you've got the rest back together, and this is where jacking under the balljoint can help.
    • One question before I make a bigger mess potentially, do I need to undo the nut on the outer ball joint? 
×
×
  • Create New...