Jump to content
SAU Community

Recommended Posts

This is a forum members 07 WRX booked in for a basic detail and correction. The car arrived and was clear that the previous owner had shares in drive thru car washes evident by straight scratches over the bonnet and roof and horizontal scratches on the tail lights!

The idea of this detail wasn’t to perfect it but to improve it to a reasonable standard. As you will see from pictures it is no where near perfect but A LOT better than previously as the job specified.

Products used:

Bowdens Body Gel- http://www.bowdensown.com.au/premium-car-care

Iron-X Soap and Nerta in foam lance- http://waxit.com.au/proddetail.asp?prod=CP172&cat=22

Iron-x on wheels- http://waxit.com.au/proddetail.asp?prod=CP15&cat=22

Menzerna Polishes- http://waxit.com.au/proddetail.asp?prod=PO250KITOEM&cat=22

Lake Country Pads

Zaino Leather cleaner and conditioner- http://waxit.com.au/proddetail.asp?prod=Zkitl&cat=67

303 Aerospace protectant- http://waxit.com.au/proddetail.asp?prod=PO250KITOEM&cat=22

Bowdens Naked Glass- http://www.bowdensown.com.au/naked-glass

Bowdens Paint Cleanser- http://www.bowdensown.com.au/auto-body-cleanser

Bowdens Tyre Shine- http://www.bowdensown.com.au/tyre-sheen

A Few prior to starting work.

IMG_4486Large.jpg

IMG_4487Large.jpg

IMG_4488Large.jpg

IMG_4492Large.jpg

Cleaning out some of the soot in the tips, you have to be carefull with this as water can damage muffler packing.

IMG_4493Large.jpg

Cleaning around the badges and in the petrol cap.

IMG_4495Large.jpg

IMG_4496Large.jpg

Bah it’s a ghost!

IMG_4504Large.jpg

Interior Before :O EEEK!

IMG_4505Large.jpg

IMG_4507Large.jpg

IMG_4508Large.jpg

All taped up ready to go.

IMG_4511Large.jpg

Some befores, afters and 50/50s

IMG_4512Large.jpg

IMG_4517Large.jpg

Before and After

IMG_4516Large.jpg

IMG_4519Large.jpg

IMG_4522Large.jpg

IMG_4524Large.jpg

IMG_4528Large.jpg

IMG_4533Large.jpg

IMG_4538Large.jpg

Link to comment
https://www.sau.com.au/forums/topic/372705-2007-wrx-wagon-detail/
Share on other sites

Japan vs Germany….Germany 1 – Japan 0

IMG_4541Large.jpg

WRX ghost gone

IMG_4542Large.jpg

USA vs Japan……sorry but Japan lost again.

IMG_4547Large.jpg

EEEEK after only one going over with leather cleaner!

IMG_4548Large.jpg

Already beading A LOT better and that is with no sealant or wax.

IMG_4549Large.jpg

IMG_4557Large.jpg

Swissvax Shield Curing

IMG_4560Large.jpg

IMG_4563Large.jpg

IMG_4567Large.jpg

Some after unfortunately it was dark at this stage so true glamour shots weren’t possible, but I tried by adjusting the shutter speed.

IMG_4570Large.jpg

IMG_4577Large.jpg

IMG_4578Large.jpg

IMG_4579Large.jpg

Hope you enjoy

Regards,

Mitch

Looks good im intrested to know a little more how you went about removing the ghosts :P

:cheers:

Removed the badge, used a product called Autosmart Tardis to remove the rest of the sticky residue then gave it a polish to get the "hologram" off of it.

If you like give me a call sometime swing past and we can remove any badges you want and fix up the holograms, wont cost much at all.

Regards,

Mitch

is that rust around your fuel cap?

Assuming your a playboy reader and didnt actually read the paragraph at the start, if you did you would relise its a clients car not mine. But yes that is oxidization around the fuel cap.

REgards,

Mitch

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...