Jump to content
SAU Community

Recommended Posts

As per title, I have a stainless X-Force cannon for sale.

It was originally off an S14 but the hangers lined up on my R33.

As pictures show it does not have a flange on it, you will need to get a flange and probably a small section of pipe welded on

Has a 3 inch inlet and 4.25ish tip

Some scratches/scrapes on the bottom. Overall condition is excellent. It is meant to exit on an angle and slightly upwards.

Any questions please PM or call/message 0432 236 396

Price: $80

Pick up preferred

canon1b.jpg

canon2b.jpg

canon3z.jpg

canon4w.jpg

canon5r.jpg

canon6n.jpg

canon7j.jpg

Link to comment
https://www.sau.com.au/forums/topic/373018-x-force-cannon/
Share on other sites

  • 4 weeks later...
  • 3 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Negative probe should be on the cars chassis. Positive on the wire.   Start as said above by unplugging everything (unplug the lights, and switches. Now at the switch, there is a wire from the fuse, to the switch, so out your positive on that terminal. It should read open circuit. If it reads something, especially a stupid low value, the short is somewhere between the fuse and the switch. If that's fine, now put the positive probe on the wire that goes to the headlight (at the switch plug). If it reads stupid low, the fault is from the switch, to the headlight.   Another quick test, is take the whole LED light setup from the left, and plug it into the right side, does it still blow the fuse? If you put the right hand side led light setup on the left hand side wiring, does the left hand side wiring now blow?  If the blowing fuse swaps from right to left doing this, your LED lights are the issue.
    • Anyone know if it's a problem to powder coat forged alloy wheel centers (Rays/Volk GT-C). some say it's bad and can damage the alloy, some say it's not a problem.
    • Hey guys, I'm reviving an old post but I'm finally getting around to working on this now. I removed the battery to get a better look at the wires and i traced the wires from the headlight to the fuse box in the engine bay, but the wiring looks fine? The wiring for the R/H headlight is 3 wires and then is bundled up with the large diameter wire that goes underneath the fuse box. I didn't take it apart yet. I know you said that its a short circuit somewhere between the fuse box and the headlight. But could it be the headlight switch on the dash? Also, i pulled out my multi-meter and set it on the Ohms, but i'm not sure where to put the negative probe and the positive probe.     
    • I have a 2 lt in Sydney. It was fitted on a R33 GTR, not used for several years . If you are interested email me on: [email protected] I'm not on this forum much .
    • Welcome. Do you plan to race? Or is this more of a weekend toy?
×
×
  • Create New...