Jump to content
SAU Community

MAS Entrants - Pre Meet 02/04

R31Nismoid

By R31Nismoid,
in Victoria

 Share

Recommended Posts

R31Nismoid Grand Master

R31Nismoid

Posted
Posted

NEW DETAILS - PLEASE READ AGAIN

Read below for the new details.

MAS - Pre meet spot will be:

LocationTodd Road - Shell Service Station - Outbound

There are two ways you can get to this.

1) Via Todd Road itself

2) Via the Westgate freeway outbound, and use the off ramp into the Servo.

Time 3.00pm SHARP

Keep this thread clear of Bullsh(t posts please guys.

Only post if your are coming - or cant come... or have a question to ask.

Link to comment
https://www.sau.com.au/forums/topic/37452-mas-entrants-pre-meet-0204/
Share on other sites
Jamezilla Grand Master

Jamezilla

Posted
Posted

Gibson car is OK for 4.00pm

They say move in time is for 5.00pm to get everyone there - if we can get any people there earlier (say 3.30pm) that would be great. Cabin are keen to move us in early as we are the biggest single group.

I will be @ MEC from about 3.00pm onwards to help co-ordinate. Will have the shirts with me. Might need someone to collect my car though...

BTW: Below are final proofs for shirts.

The stitched logo looks fantastic - shall do a run of men's polos after the show :(

Sass Grand Master

Sass

Posted
Posted
Gibson car is OK for 4.00pm

They say move in time is for 5.00pm to get everyone there - if we can get any people there earlier (say 3.30pm) that would be great. Cabin are keen to move us in early as we are the biggest single group.

I will be @ MEC from about 3.00pm onwards to help co-ordinate. Will have the shirts with me. Might need someone to collect my car though...

BTW: Below are final proofs for shirts.

The stitched logo looks fantastic - shall do a run of men's polos after the show :(

whats the go with the stitched logo james? are they to go on the polos?

Snowman Grand Master

Snowman

Posted
Posted

Well I was speaking to John from Exclusive and they have been told to get there at 4pm (they have 16 cars btw - not 6) so I think Cabin are damn confused fools for sending us an email saying 5pm - sending others emails saying 4pm and then telling you they want us early.

R31Nismoid Grand Master

R31Nismoid

Posted
  • Author
Posted

Ah FARKEN CABIN!

Ok, change of plans guys. New Arrival Time has been requested

Can we all meet at the Servo at 3pm ?

Cabin would now like us in at 3.30pm, or around that time.

Please post up if you can make it.

If not, that is ok... Just come when you can. But we want the majority or cars in at 3.30pm.

Thanks and sorry to stuff everyone around.

Cabin are a law un-to themselves.

Any problems Call me, dont PM me.

0408 33 77 07

-ash

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      R34 Gtt Wheel Offset Advice

      By GTSBoy · Posted

      What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • silviaz
      R34 GTT idle problem

      By silviaz · Posted

      I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • Kinkstaah
      R34 Gtt Wheel Offset Advice

      By Kinkstaah · Posted

      This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • AdiR34
      R34 Gtt Wheel Offset Advice

      By AdiR34 · Posted

      Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...