Jump to content
SAU Community

Recommended Posts

Hey guys,

I have a R33 series 2 manual gearbox for sale.

I bought it as a spare box for my R33 but I am selling it to fund my RB26/30 build

Great condition

Came out of a Halfcut with 47xxxkms

Comes with shifter

Box also come with modified Xmember to suit R32 conversion

$1500.00 FIRM

We all know these sell all day for this money and are worth it so dont low ball as I am not desperate to sell this item.

Located in Upper Mount Gravatt

Call/sms 0408605725 or PM here

r33box3.jpg

R33box1.jpg

r33box2.jpg

Link to comment
https://www.sau.com.au/forums/topic/374720-bris-r33-rb25-sii-manual-gearbox/
Share on other sites

If buyer is in Brisbane area I will take up to $500 in parts as a part trade. I am looking for Haltch twin port coils, acl race bearings to suit RB26, r33 GTR seats front and rear, R33 GTR guards in white with guard raisers, engine crane, engine stand, Drift wing or forged S2 RB30 bottom end to suit RB26/30 application.

Edited by polishstorm
  • 2 weeks later...


  • Similar Content

  • Latest Posts

    • Haha yea it's a bit of a weird setup at the moment, just wanted to make sure I sorted out any headaches before dyno day. At the moment I've changed the exhaust manifold, turbo and downpipe, 460lph fuel pump and rising rate reg as well as the previously mentioned headstuds and gasket. The nistune was already mapped for the car as it was and drove around for a few months no worries. The plan is to run flex fuel hence the big pump, which I've wired direct to the battery through a relay to avoid voltage issues.
    • Um. Was the ECU the same as the one previously there? I know R33's needed R32 GTST ECU's or other tomfoolery to run Nistune. This is such a wild setup. Most people would plumb in the turbo then not drive the car (i.e tow it to a tuner). What's actually changed since it last ran?
    • I'm a bit stuck with this one fellas, I recently decided to undertake a turbo conversion on my GTS-4, ended up pulling the motor to replace all the seals and do an mls head gasket and arp head studs while I was at it. Everything has gone according to plan, no oil or coolant leaks, compression checked out, and decided to give it a test before I book it in for a tune As it stands right now, the turbo only has oil lines plumbed so that I don't put boost into my untuned engine, and I'm using the factory GTS-T crossover pipe with a maf and poddy as a temporary intake. The car starts with relative ease and idles amazingly, however as the title suggests it really doesn't want to rev up, runs very smooth but almost feels choked out and unresponsive to the throttle, almost like it's running lean or something? I've triple checked my vacuum lines and timing with a timing light, injectors haven't been touched as of yet to avoid flooding the engine and worked perfectly beforehand, new plugs and coilpacks, I've even unbolted the cat just to see if it spontaneously collapsed, no dice The car currently has a nistune r32 gtst ecu installed so I have no way to check for fault codes. At this point I'm a bit stumped. Is this normal behaviour for a car with a turbo bolted onto the exhaust going nowhere? I'd imagine the turbo wouldn't cause this much restriction in the exhaust without the boost going through the intake. Any ideas? If necessary I can link a video of how it responds to full throttle while in neutral.  
    • Insert tab A into slot B?
    • Instructions seem simple enough to understand.....
×
×
  • Create New...