Jump to content
SAU Community

Recommended Posts

Time to clear out the shed and getting rid of all the GT-R parts I have collected over the years. I have the following available:

First up is a complete cylinder head with plenum, exhaust manifilds, cam covers, basically everything is there to bolt up to a block. Fuel injectors, coil packs, crank angle sensor and turbos are all that's missing to make it a complete top end. This head has undergone some major custom work by Racepace Motorsport and is basically a one off. It has been reconditioned with new valves and most importantly has had some port work which resulted in valuable gains. The power came on earlier and also benefited from top end aswell. This costed me a considerable amount of coin so those of you who are after a basic head need not apply. The head uses standard cams which worked really well with the modifications to the head and also benefits from keeping the engine sounding and idling standard, good for keeping away unwanted attention. This head came off my car which had done around 500kms of street driving, I have not used this on the track, so basically it's like new. It also has Racepace adjustable cam gears(500kns old).

PRICE: $3200 ono for everything mentioned above...

Xforce stainless split dumps suit R32, R33 and R34 GTR, used but have no cracks, in very good condition.

05072011337.jpg

05072011338.jpg

PRICE: $300 ono

Series 3 GT-R gearbox with transfer case. This gearbox was rebuilt with new bearings and series 3 synchros and has done approx 2000kms. The transfer case has been modified by Racepace Motorsport to give extra torque to the front wheels. Made a big difference on the track as the car had much more stomp out of the slower corners. It had fresh redline oil put in it when it got rebuilt.

PRICE: $2750 ono

Cusco front adjustable upper control arms suit R33 and R34 GTR only. These have been modified by Racepace Motorsport to improve turn in. Can achieve -3.5 degrees of camber using standard lower control arms. Used but in very good condition.

PRICE: $450 ono

TEIN Circuit Master RS coilovers suit R33/34 GT-R's only. These were revalved and rebuilt to Racepace's custom specifications, and has also custom spring seats to accomodate custom springs. They are a worthy investment for any track orientated car. They are also an awesome package for the street, not that harsh of a ride considering how good they are for the track. I have done a 1:18.7 at Sandown with this setup so definetly worth the money.

PRICE: $4250 ono

R33 GTR short motor, includes N1 water pump (near new), oil pump, balancer, crank, rods and pistons. Was compression tested before being removed from car and was down on 2 cylinders. Its a standard bottom end and the block has not been machined. Ideal for someone wanting to rebuild an engine on the side without having their car off the road.

PRICE: $850 ono

R34 GTR standard sump and diff. Came off an engine that had done 72000kms. In very good condition.

PRICE: $800 ono

Standard RB26 cylinder head out of an R33 GTR, has been crack tested and is OK, suit reco, no cams, cam covers, valves, springs, shims, retrainers. Bare head only but has had a dash fitting pressed in for oil drain at the rear. Has slight markings on journals as pictured below.

31072011407.jpg

31072011408.jpg

31072011411.jpg

31072011412.jpg

31072011414.jpg

31072011406.jpg

PRICE: $300 ono

Currently all items are located in Narre Warren North in VIC, but will post items interstate at buyer's expense.

PM or reply here if interested.

Cheers,

Jack

Hey mate.

Interested in the block and bare head.

Does the block come with windage trays and crank girdle?

What does the crank look like? Any damaged big end bearings? Able to reuse the crank without linishing?  Brad

Edited by Just_a_datsun

Hey mate.

Interested in the block and bare head.

Does the block come with windage trays and crank girdle?

What does the crank look like? Any damaged big end bearings? Able to reuse the crank without linishing?  Brad

Hey Brad,

Yeah mate, windage tray and crank girdle are all there. Basically only the head and sump were removed.

This was a running engine before pulled out of the car. Was down on compression on two cylinders but after removing the head could not see any damage to the rings so not sure why it had low compression. There is no damage to the crank or bearings.

Are you in Melbourne? If so you are more than welcome to have a look.

Cheers,

Jack

Am I reading correctly. $4250 for second hand coils?

Yep, if you want stuff from racepace, you'd better open your wallets as they aren't cheap.

Best of luck in selling your stuff jack, and you gotta take me a ride in your GTR!

Anything to do with GTR's ain't cheap!!!!!

These coil overs are not off the shelf items, in fact they are discontinued and not available new anymore. They have been totally rebuilt and customized to be exceptional on the track aswell as on the street.

I understand that they are not for everybody, but those in the know will vouch for their performance and the price that goes with it....

More PM's replied.

Cheers,

Jack

No, unfortunately I am in Brisbane, hence the 20 questions.

Would you consider delivering the engine to a courier depot (would need to be on some sort of palet that they can forklift)?

Or better yet organise transport to brisbane?

Brad

Edited by Just_a_datsun

Hey Brad,

Putting it on a pallet and sending it up to you will not be an issue.

Can you send Private Messages yet? I think you need more than 5 posts.

If you can send me your email address I can send you photos and more info.

Cheers,

Jack

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...