Fs: Alcon V8 Supercar Brake Setup, Front And Rear To Suit R32/33/34 Gt-R

[Sub Boy32]

JAGR33

I See that the brakes have sold, But I was wondering if you could answer a couple of questions regarding them for me?

What brake master cylinder were you running with them? Stock R33? If so did it have much freeplay in the pedal? Long pedal?

Did you still retain the ABS, Or was it removed?

Who made up the hats and dogbones for you? would they still have the measurements to make another set? or sell me the CAD measurements?

I'm looking at running a set under the same wheel you have shown in the photos (Enkei RPF1 18x10.5 15 offsett) there was no issues with those fitting?

Thanks for your time,

Chris.

[JAGR33]

Jack. I can provide

Would you like carbon pads with that? double .

Tempting!!!!! Remember you posting years ago about your collection of brakes, insane.....

Awww damn... I was even considering buying these off you Jack!! I don't even have a GTR to put them on, but I would have found a way to fit them to the S15 Nevermind.. I am still rather envious though

You have two sets of Alcons already, that's enough for you buddy boy!!!!!!

So what mods are planned for the evo?

None for now, keeping it stock so it doesn't cost me too much money to maintain....

JAGR33

I See that the brakes have sold, But I was wondering if you could answer a couple of questions regarding them for me?

What brake master cylinder were you running with them? Stock R33? If so did it have much freeplay in the pedal? Long pedal?

Did you still retain the ABS, Or was it removed?

Who made up the hats and dogbones for you? would they still have the measurements to make another set? or sell me the CAD measurements?

I'm looking at running a set under the same wheel you have shown in the photos (Enkei RPF1 18x10.5 15 offsett) there was no issues with those fitting?

Thanks for your time,

Chris.

[JAGR33]

JAGR33

I See that the brakes have sold, But I was wondering if you could answer a couple of questions regarding them for me?

What brake master cylinder were you running with them? Stock R33? If so did it have much freeplay in the pedal? Long pedal?

Did you still retain the ABS, Or was it removed?

Who made up the hats and dogbones for you? would they still have the measurements to make another set? or sell me the CAD measurements?

I'm looking at running a set under the same wheel you have shown in the photos (Enkei RPF1 18x10.5 15 offsett) there was no issues with those fitting?

Thanks for your time,

Chris.

Hey Chris,

I was using the standard master cylinder with ABS, did not have free play or long pedal at all, in fact needed much less force on the pedal to stop, basically you could rest your foot on the brake pedal and your eyes tried to detach themselves from your skull. Very firm pedal, was very impressive.

PWR in QLD did the adaptors and hats, they have the drawings and dimensions.

I wouldn't run them with the Enkeis, there was only about 1mm clearance between the caliper and the rim, if a stone got in there it would make a mess. Nismo LMGT4's or TE37's would be your best bet....

Hope that helps...

Cheers,

Jack