Kill Switch - Ca18

[No Crust Racing]

Afternoon Gents.

I'm just finishing off my batter relocation at the moment and am in the process of wiring in a kill switch in the engine bay.

Where's the easiest place for me to pick up an ignition signal to cut when the switch is activated so the engine actually stops as well as disconnecting the battery? Battery disconnect already working fine.

I'm just using a standard 2 pole isolator switch, nothing fancy.

[No Crust Racing]

Sorted this, wired up the alternator to the battery side of the switch so when the switch is pulled there's nothing on the engine harness side to provide any power at all so the car stops and cannot be restarted until the switch is reset. Pull tab is located near the base of the windscreen just below the A pillar on the drivers side.

[MsR]

mine was in between the battery (boot mounted) and main positive terminal in the engine bay. the switch was mounted in between the rear seats right at transmission tunnel for easy access