Jump to content
SAU Community

Recommended Posts

Hey guys,

as a heads up, the front seatbelt assembly's are sold, also sold lots of smaller pieces.

Will add another post today with more pics / info on whats still being sold.

Hey guys,

also selling these pieces, most of them belong to my dash surround.

All of the controls themselves are in immaculate condition, with the letters and writing intact.

I am selling each piece separately as I don't have one of the control units (Light switch) any more so cant sell it complete.

I am selling them at the following prices:

Dash Surround: $35

Radio / Emergency Button: $15

Fog Lights / Rear Heater Button: $15

Windscreen wiper turn knob: $10

Windscreen wiper coverplate: $10 (immaculate condition, lettering is flawless)

Windscreen wiper covercap button: $10

Rear sealtbelt cover plastic: $5

regards

post-85874-0-30647500-1319942001_thumb.jpg

post-85874-0-31124600-1319942004_thumb.jpg

post-85874-0-32536200-1319942008_thumb.jpg

post-85874-0-21238500-1319942012_thumb.jpg

post-85874-0-18686400-1319942016_thumb.jpg

post-85874-0-15806700-1319942019_thumb.jpg

post-85874-0-17689400-1319942022_thumb.jpg

post-85874-0-91343600-1319943595_thumb.jpg

post-85874-0-26991500-1319943600_thumb.jpg

post-85874-0-06079100-1319943604_thumb.jpg

post-85874-0-83557700-1319943606_thumb.jpg

post-85874-0-81780500-1319943610_thumb.jpg

Hey mate im after a couple of things for a r32 gtst and hopeing you can send them interestate to 3030

im after the surround that goes arund the stereo and air con, the center vents, the slave cylinder]and the knob to turn the headlights on

post-88740-0-07478700-1320224390_thumb.jpg

post-88740-0-76281800-1320224527_thumb.jpg

post-88740-0-66520800-1320224614_thumb.jpg

  • 2 weeks later...

I'll take the 32 steering wheel if u still have it,

Plz pm me asap

Hey guys,

In response to the guy a few posts up, sorry I dont have the Air con Grills, Outside Surround Piece or the mechanicals your after, just the stuff I have listed (they are spares from my old R32)

Dont have anymore R33 parts either, they have all been privately sold.

I still have the R32 Steering wheel, so if anyone is interested.

Ive also sold lots of small miscellaneous piece

Hey guys I still have the following parts for sale:

1 X R32 Dash - Small 2cm bubble directly above the passenger side glove box

1 x R32 Driver Side Exterior piece (looks like an L shaped plastic piece)

1 x R32 Passenger Side exterior piece (Same as above)

1 x R32 Power Steering Pump

1 x R32 GTR badge (unsure if genuine)

1 x R32 side GT badge (green)

1 x R32 front badge (green)

1 x R32 Dash Surround (holds the lights, emergeny, rear-demister switches)

1 x the following switche (rear windscreen wiper, front windscreen wipers, radio + emergency, rear-demister + fog lights)

1 x R32 Drivers side power mirror

1 x After market pod filter to suit R32 (with external heat shield)

1 x Drivers side standard orange indicator

2 x arm rest vinyll covers

1 x R32 Steering wheel.

1 x R32 exterior outside trim piece

Be great if I can clear these out soon. Sold lots already but would be good If I can sell these off to forum people instead of just dumping them in the trash.

Contact me if your interested in any

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Add to this... What blew the fuse too? If a circuit feeding power to the coils was blown, how were the coils even functioning to let the car start?   There is some seriously wrong wiring in that car for certain, and I'm betting there is some melted cables somewhere, but I can't explain the 30v either, unless there is something back feeding on that power line that has a dodgy power system and the electronics are giving it hell.
    • This is typically the case with such threads. What I cannot quite get my head around is where a reading above 12V (or 13.8 or 14.x or whatever the maximum achievable voltage might actually be in that specific car) comes from. 25V or 30V should be completely impossible. There's no way to create it. Hard to answer that question. It will literally depend on whether the current tune relies on the values as set. I'd guess it probably does. ie, the real base pressure being 49 means that the flowrate through the injectors will be higher than if it was 43.5. The Haltech's modelling should be handling that, but because it thinks the pressure is only 43.5, then..... I dunno. It should be thinking that it will be injecting less fuel with each pulse duration than is actually happening. So, something is definitely not-as-it-should-be, but specifically what that is is beyond my abilities to imagine. Someone like Dose who spends more time with Haltechs might have a better thought.
    • Bit of a late reply here as me and my wife have been really busy with new born twins. I finally got these issues fixed and it was something really stupid that caused all of this 🤦‍♂️... After alot of mucking around with trying to figure out what is causing these issues, I back probed one of the R35 coils on the power 12v supply, with the engine running it got 25v! And I thought, hang on..., this isn't normal. Measured my battery with the engine running to check for over charge from the alternator and it wasn't that. So then I dissconnected the R35 PRP coil harness and backprobed the power supply on the engine loom where the ignition coil harness connects, with the key on ignition (engine off) it measured 30v! So then I had to trace where that high voltage was coming from and it lead me to the brown relay "ECM & IGN coil relay" inside the cabin next to the ECU on the passanger wall. This relay feeds power to the ECM and ignition coils. Tried swapping it with another same relay. nah still 30v.. coming from the 2 green/white wires in the brown relay. So then I set my multi meter to the beep continuity mode and probed every fuse on the fuse box inside the cabin to try and find this high voltage power source. Wasn't any of the fuses inside the cabin. Then probed all the fuses in the engine bay and BAM, got my power source that was a 10AMP fuse called "ENG CONT". Pulled the fuse out, and what do you know... it was blown. 🤦‍♂️  So then I quickly replaced it with a new 10AMP fuse, started the car and yeah haha [insert extreme face palm]... The RPM blimping thing went away, car idles smoothly now like what it was before. I swear! I checked all my fuses with my test light twice before I created this forum thread. I think, maybe because one side of that faulty 10A fuse lit up on my test light, I must have thought it was still ok and not blown. But now I know to have both sides light up on the test light when checking fuses... I hate diagnosing electricals.... I'd take mechanical problems over electrical problems any day🤣. Drove the car around my suburb with the engine up to operating temp and it runs fine like before. However, I notice that my fuel pressure is still at 49psi. So I'm thinking this must be normal for my system as I've upgraded the stock fuel pump to a Walbro 255L/h with a constant 12v mod.  But anyway, I'm just glad to have my daily back on the road! Thanks everyone for the replies on this thread, all sorted now! One thing I want to ask you tuner guys, my base fuel pressure on the haltech main settings are set to 43.5psi from default (my tuner must have not checked the fuel pressure maybe when tuning my car?). Do I set it to what it actually is idling on at 49psi? Or just leave it ("if it aint broke, don't fix it/leave it")?  
    • The max they would go for me is 50.
    • That cannot have been a fun set of drilling. The stock "baffle" looks identical to rb26, I just cut fuel cell foam to fit the full length under the baffle.
×
×
  • Create New...