Jump to content
SAU Community

Recommended Posts

FOR SALE :

1998 R33 GTR VSPEC series 3 

KN6 (Dark grey/purple/blue pearl )

88,000kms

FIRM $28,000

Hello i have come to the sad conclusion that it is time to sell my Gtr . I have a few debts and Can no longer Afford to keep it . 

This is a fine example of a genuinely original S3 GTR . I searched a long time for a series 3 and came across this fresh from Japan . I am the first owner in Australia and it was complied and bought from NAGOYA MOTORS in May 2011 . 

1998 VSPEC which has ATESSA-ETS PRO unlike the standard Gtr r33 which have the non pro version , also this s3 has updated 4WD computers compared to s1/2 . The ABS module is also S3 only with 4 channel independent wheel abs (r34 Gtr) . A-LSD (active LSD) and few other mechanical differences I've seen across a few models .

The car is completely stock! I mean down to a Nissan tape player and no mods under the hood at all , the car remains as it was from the show room floor and the condition is also like new! 

I have lucky to fall upon an exhaust which is amazing quality , I only wanted to source the best parts which is why i went with FUJITSUBO GEIKEN. 

FGK Titanium (TUNED LENGTH) front pipe , it's a beautiful front pipe that has equally tuned length from both turbos , it wraps around the bell housing towards drivers side and joins back to the cat and sits tight on body.

FGK Titanium Catalytic Converter 80mm in/out , flat style for ride height . 

FGK Titanium Twin 60mm cat back . Sits tight and looks amazing underneath car , joins into a large ovel muffler and Still remains twin inside the body of muffler to a single 4" tip .

The car has been my pride and joy and I have done nothing but look after her . Since I've purchased the car I have had ZERO mechanical issues at . It seriously is like driving it new. 

I have taken it to WSID for a run down the 1/4 and got a time of 12.53 @ 178km/h . Which is amazing for factory trim . 

The boost is running 0.9bar and fitted with a xtreme HD ORGANIC clutch .

Call Glen on 0433818248

454d4065.jpg

2cd8b202.jpg

3434ac0b.jpg

78aaeeb5.jpg

f4a366d1.jpg

ff63c3d7.jpg

609cd6ec.jpg

c71fc627.jpg

86eb8d58.jpg

Link to comment
https://www.sau.com.au/forums/topic/378929-1998-r33-gt-r-s3-vspec/
Share on other sites

  • Replies 49
  • Created
  • Last Reply

Top Posters In This Topic

  • 1 month later...

Hi Mate, is this car still for sale - including the titanium exhaust system? I might have a buyer liner down here in Victoria. Just need to get him to have a good look over the car.

Cheers.

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • hrmmm , not mine , easter plans to pull engine not happening     
    • I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...