Rb25 And Box

[luvboost]

I'm going to get a 25 and box for my 32 next week has any one got some where they recommend or where not to go? Or should I just got jpc, kyp?

Thankyouuu =)

[Hank Scorpio]

Go to JPC, Danny always sorts you out

[bubba]

[email protected]

[-Macka-]

+1 For maytech, Top bloke at realistic prices

[luvboost]

3300 for a 33 half cut from maytech so is it very hard to swap the the 20 to 25?

[turboedsloth]

Its a piece of piss, some fiddly bits but are very easy to overcome. There is a tutorial on how to do the swap in the DIY section if i remember correctly

[Flash89]

need to modify gearbox mount and a custom tail shaft. othen then that everything else should bolt in and a bit of wiring too

[luvboost]

is the modifying very hard cause im looking at doing it myself but i have never done any coverisons before?

[StevenCJR31]

if you are unsure of your skills then play it safe and take it to a workshop

[luvboost]

Yeah I might, just I wanted to learn haha

[Flash89]

the gearbox mount would need 2 small steel plates welded on, others might do it differently as the holes from the mount to the chassis is about an inch or 2 different, as with tail shaft you will need the rb25 gbox yoke and get it measured and have a driveshaft place to make up a tailshaft for ya