Jump to content
SAU Community

Recommended Posts

lol, i'm not working now so thought i'd give it a miss.. but i'll shave just for you <3

coming out tonight?

I'm at a mates house and I'm hugely tired, my only driving will be Mario Kart :) Ride tomoz if it's dry?

haha yeah bro, anytime. sort of. still have two exams left haha, will be really free after the 19th! hopefully the weather clears up too ! :D.

but depending on how lazy i'm feeling (towards study) possibly up for it beforehand xD.

lol that's what i thought. would certainly be impressive economy for a car with some performance :P

haha you would be surprised how well the tdi goes, especially that its 2litre and been tuned :P

55621939736797696731114.jpg

WUT! Da Faq!

Yanks always gotta push it that one step further :laugh:

s13 convertible with 32 front

haha you would be surprised how well the tdi goes, especially that its 2litre and been tuned :P

Haha really? figured they were zippy, but yeah :P. always looked at R32's and GTI's (and now R's). Only can drive R32 though, and that's too $$$ for me :(.

Mate has a smaller engine mk6 tdi or tsi... tells me about his economy and i go cry in a corner

Last exam on the 20th here. And I haven't been studying at all... LOL

Leggo cruise tonight!

OK THEN rofl. Dunno how long can come out for, but why not :P. Will regret later.

Edited by kaitoukid

Haha really? figured they were zippy, but yeah :P. always looked at R32's and GTI's (and now R's). Only can drive R32 though, and that's too $$$ for me :(.

Mate has a smaller engine mk6 tdi or tsi... tells me about his economy and i go cry in a corner

OK THEN rofl. Will regret later.

Your able to drive any of the tdi's as well, because it's diesel its not classed as performance

the r32's have limited tuning too unless you drop big $$ into turbo or supercharger kits being a NA 6

Your able to drive any of the tdi's as well, because it's diesel its not classed as performance

the r32's have limited tuning too unless you drop big $$ into turbo or supercharger kits being a NA 6

Ah yeah. I sort of meant out of the box. R32 was the one of choice since no gti.

Aaron, those 275's do nothing for you. With that camber, you only have half of the tyre on the ground (could see the wet part of the tyre)

.5" smaller or more offset, less camber, and you'll have way more tread on the ground.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...