Jump to content
SAU Community

Recommended Posts

614810_10150950810824249_703974145_o.jpg

saw this on fb.

also saw two brz's out front of autobacs in tokyo bay when i was there (i have photos somewhere). also another citrus coloured s14 like another resident of the board *coughaaroncough*

Aaron, estimation on how long it'll take to do two guards? Planning to keep the guard lining, but just cutting some out at the top.

Jeez your a slack flamin mongrel. Depends on how good you want it to look = how long I take

m8... give me ball park figure mun, i want it good, real good, just rolling them though, no flare.

Planning to go to yours after work on saturday. could be at yours at around 6-7~

Would be better during the day if u can. Should take an hour or two at max

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Adjusting the idle screw is usually (emphasis on usually) just covering up deeper issues. Stuff like the cold start valve not closing properly. Throttle shaft seals on the way out. Coolant temp sensors getting out of spec. Coolant temp sensors especially can be a bear to diagnose because they can fail subtly. My dad just spent weeks chasing down his high idle. He cleaned the coolant temp sensor and everything but the resistance curve just drifts over time and if it's been 20+ years they also get super slow to respond as well. Has a massive effect on fuel economy as if it's off the ECU is going to run richer and command high idle for far longer than it should otherwise.
    • How old is the battery, it's more likely your battery is on its way out.
    • I reckon you'd get 90% off. My washer doesn't get between spokes very well. Haha! I love my Gerni!  Argh! Steam cleaning has its place for sure.
    • Hey all, I did a voltage test with the car (video attached) not running for 3 days. And here is some interesting stuff: - Battery voltage is 12v (I had the key in the ON position) - Drops to 9.76v while cranking then quickly goes up to 14.5v - You will notice there was a sorta slow start but not as slow as it usually is. - Idle surprisingly was better at just over 1,000rpm instead of 1,100 rpm. - I turned on the A/C, radio and headlights in the video and the voltage remains the same - I haven't cleaned the grounding wires on the chassis yet, that's next. - Battery drops to 12.6v when I turn off the car and wait a bit Seems like I might have a parasitic draw? I do have an immobiliser system which does drain the battery more of course but was wondering if there is anything else I should be looking at fixing? Does the ground wires on the chassis have anything to do with the low 12v?        SAU.avi
    • My lord that is some low oil pressure as minimum in the manual! I guess the big part will be seeing how it changes as the engine gets more spirited use.
×
×
  • Create New...