Jump to content
SAU Community

Recommended Posts

I warned him before he bought them lol. He said nah, I got good luck since putting them on.. Lol

Poor alwina

beats having a 32R disappear on you

That said, this is what the defect notice says.

1. Air cleaner - to be secured

2. Rear wheels, to be covered to axle height.

no rwc required.

Will cable tie down the pod, and also, put on the wheels off the v35 on.

He tried to tell me my car needs Z rated tyres. like reary?

So fingers crossed, when the epa comes, its just noise, i know its not possible, but a man can hope.

thought you said semi's....

RS-R def not semi's

It's weird, half the places I look advertise them as semi slicks, but they look like (and have the specs of) like... extreme performance tyres. Either way, bang for buck it looks like they're what I'm after :)

It's weird, half the places I look advertise them as semi slicks, but they look like (and have the specs of) like... extreme performance tyres. Either way, bang for buck it looks like they're what I'm after :)

Yeh they are pretty good tyres, they screech abit but like Martin said. Not semi.. Borderline though

as a general rule, semi is lower than 100-120 wear rating

rs-r are 140,

my R888's are street legal so it not like that a hard thing.

o rly?

im looking at getting semi's sometime next year, so will be doing some research then.

Edit: can anyone recommend a decent place for interior detailing? south/east regions

o rly?

im looking at getting semi's sometime next year, so will be doing some research then.

Edit: can anyone recommend a decent place for interior detailing? south/east regions

yeah msot sold in AU are, RE55's R888 A048's

all street legal.

plus my R888's were cheaper than my RS-R's i had b4!

o rly?

im looking at getting semi's sometime next year, so will be doing some research then.

Edit: can anyone recommend a decent place for interior detailing? south/east regions

immaculate reflections?

lol

beats having a 32R disappear on you

That said, this is what the defect notice says.

1. Air cleaner - to be secured

2. Rear wheels, to be covered to axle height.

no rwc required.

Will cable tie down the pod, and also, put on the wheels off the v35 on.

He tried to tell me my car needs Z rated tyres. like reary?

So fingers crossed, when the epa comes, its just noise, i know its not possible, but a man can hope.

If he saw the bleed valve then that's a full EPA. The same goes for intercooler an airpod.

Vicroads staff don't know what bleed valve is. They will look at wheels and pod and go back.

yeah msot sold in AU are, RE55's R888 A048's

all street legal.

plus my R888's were cheaper than my RS-R's i had b4!

Where does one acquire cheap R888's.?

If he saw the bleed valve then that's a full EPA. The same goes for intercooler an airpod.

Vicroads staff don't know what bleed valve is. They will look at wheels and pod and go back.

I better tape up my bleed valve with black tape once my tuned is finished then :ninja:

Coming to GC tomorrow night Pat?

I better tape up my bleed valve with black tape once my tuned is finished then :ninja:

If you've got the stock airbox, you can tuck it under there pretty nicely as well. Makes it super hidden.

That's pretty cheap!

Still a bit more than I wanted to spend on DECA and a few track days.

$240 fitted for a 265/35/18 595RS-R

vs

$730/2=$365 unfitted,unshipped for a 265/35/18 R888

Different league of tyre I know, but for my level of competition... its a bit more than I was willing to spend this time around, considering I just bought a grand worth of rims as well :( Wallet hates me enough already.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I don't think there's any way someone is push starting this car.. I honestly can barely move it, and moving it and steering it is just flat out not possible. I'm sure it is, but needs a bigger man than me. I have a refurbished starter now. The starter man was quite clear and consise showing me how nothing inside a starter really should contribute to slow cranking, and turned out that for the most part... my starter was entirely fine. Still, some of the wear items were replaced and luckily it didn't show any signs of getting too hot, being unfit for use, etc. Which is 'good'. I also noticed the starter definitely sounded different, which is a bit odd considering nothing should have really changed there.... Removed and refit, and we'll pretend one of the manifold bolts didn't fully tighten up and is only "pretty" tight. GM only wants 18ft/lb anyway. I also found a way to properly get my analog wideband reading very slightly leaner than the serial wideband. There's Greg related reasons for this. The serial output is the absolute source of truth, but it is a total asshole to actually stay connected and needs a laptop. The analog input does not, and works with standalone datalogging. Previously the analog input read slightly richer, but if I am aiming at 12.7 I do not want one of the widebands to be saying 12.7 when the source of truth is 13.0. Now the source of truth will be 12.65 and the Analog Wideband will read 12.7. So when I tune to 12.7 it'll be ever so slightly safer. While messing with all of this and idling extensively I can confirm my car seems to restart better while hot now. I did add an old Skyline battery cable between the head and the body though, though now I really realise I should have chosen the frame. Maybe that's a future job. The internet would have you believe that this is caused by bad grounds. In finding out where my grounds actually were I found out the engine bay battery post actually goes to the engine, as well as a seperate one (from the post) to the body of the car. So now there's a third one making the Grounding Triangle which is now a thing. I also from extensive idling have this graph. Temperature (°C) Voltage (V) 85 1.59 80 1.74 75 1.94 70 2.1 65 2.33 60 2.56 55 2.78 50 2.98 45 3.23 40 3.51 35 3.75 30 4.00   Plotted it looks like this. Which is actually... pretty linear? I have not actually put the formula into HPTuners. I will have to re-engage brain and/or re-engage the people who wanted more data to magically do it for me. Tune should be good for the 30th!
    • There are guys on Facebook under, Infiniti Owners Australia   https://www.facebook.com/share/g/1Z3RbPqx4k/?mibextid=wwXIfr What Whp are you after and I can help, and join this Q group in the states. https://www.facebook.com/share/g/19A59cN3JR/?mibextid=wwXIfr
    • Does any of you guys have instagram pages for your builds? Keen to see some Aussie builds. I still can't figure out how to post photos in here.
    • That awesome thanks for that. 
    • You can Remote any of these VR30..globally  Check: AMS Performance | Racebox | Sonic Tune | Soho | Z Motorsports | Specialty Z    Performance Parts | AMS | Z Motorsports | Boosted 6 |    Exhaust | Fast Intentions | ARK | MBRP Motordyne | Borla    There is someone in Sydney with 650whp   I am at 430whp without flex fuel, but FBO & Flex-fuel will push you to 500whp!!  
×
×
  • Create New...