Jump to content
SAU Community

Recommended Posts

yeah i would load up sau and realise it was down and was pretty much 'f**k what do i do now'

hahahaha me too! I prob wouldn't even need the net if there wasn't sau.

That sounded sad... :unsure:

Enter DECA then.

Are you going deca grant?

Yeah rear passenger wheel slight flat spot.

Drivers completely destroyed and wheel twisted around completely it's f**ked and so is the suspension. Nothing gone but the subwoofer in the boot, maybe the gopro, haven't looked inside cos has to be fingerprinted.

yup. garage will be locked from now on.

had a break in recently. some kids entered and stole my fishing bag. and my 6in extension.

the 6in extension is cheap. but the 1999 shimano chronarch is impossible to find in good condition anymore.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hey everyone!!  I've noticed that whenever I do my oil changes, after putting 4L in, the oil level sits at the top mark in the dipstick. This is after letting the old oil drain for a very long time too! I've checked the oil level daily for the past few mornings. It happens every time and it's confusing because all the threads say that it should take about 4.7L (With some just adding the full 5L) My next thought is to figure out if the dipstick I have is correct so could someone please tell me the length of the RB25DET engine oil dipstick?  I've checked images of some of the genuine dipsticks, but none of them have the length in it. https://justjap.com/products/genuine-nissan-engine-oil-level-dipstick-fits-nissan-r34-skyline-c34-stagea-c35-laurel-y34-cedric-gloria-rb25de-t-neo?currency=AUD&srsltid=AfmBOortQXofgmiHVRKuIaiKuygL4k0Ewp68c3isGZk0vvKOJ7Yqf3iB However.... the engraving on the genuine ones say 05002 while mine says AA000. This makes me believe that maybe I have a wrong dipstick? I just want to confirm before I buy a new one. The car is a fresh import from Japan so I don't have details of the previous owner to ask him. Thanks in advance 🙏🏾 
    • Sport. I didn’t rebleed it cause I just removed the slave and left connected.    I will change line and slave and see how it goes.  
    • Oh and how is the rattle when foot is on the clutch ?
    • Did you get the sport or track ? From what the documentation says the uniclutch has a small amount of movement to disengage.  So your story of tricky pedal setup seems common.    Hopefully you got it bled up too, as the bite point moving around is usually either plates wearing in or air in the line.     
    • There's always "MIG it up and grind it back".
×
×
  • Create New...