Jump to content
SAU Community

Recommended Posts

hmmmmm
http://www.skylinesaustralia.com/forums/topic/422421-gt-r-34-rolling-shell/

Saw Vu's old GTR at Sabbadin Automotive the other week. guys there said the latest owner couldnt drive it (im assuming on their P's). Either way, hopefully the car hangs around the scene. Wonder if he'll sell the plates seperatelykreewffea

2mm panel gap on a 15~ year old car...uhoh lol

Who could even notice 2mm other stuff sounds fair enough though. Panel beaters would have given zero fks they are useless pricks

Not 2mm panel gap.... a 2mm variation between the panel gap at the top and at the bottom... The door actually sits further away from the car than the surrounding panels. (2mm might be a slight exaggeration, but its very noticeable)

I left it in the factory at work last night and took the gf's car home, got into work this morning (1.5h Public Transport *ewwww*) I took a closer look at it, and most of the issues seem to revolve around the fitment of the window glass. It's like it's been installed too low... so it's hitting the rubber as the door shuts instead of slotting nicely into the gap as it should

hmmmmm

http://www.skylinesaustralia.com/forums/topic/422421-gt-r-34-rolling-shell/

Saw Vu's old GTR at Sabbadin Automotive the other week. guys there said the latest owner couldnt drive it (im assuming on their P's). Either way, hopefully the car hangs around the scene. Wonder if he'll sell the plates seperatelykreewffea

Saw that thread...

Seems strange to want to sell it due to his P's. His had the car for a while now, so its not like he didnt know about it when he bought it

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...