Jump to content
SAU Community

Recommended Posts

Anyone want to buy some evo gear?

Built evo 8 head to suit evo 7 (kiggly beehive springs, 1mm os intake and exhaust valves, ported and I'm sure there is other stuff done I'm forgetting.

2.3 stroker with eagle forged crank (4340), eagle rods, arias 8.5:1 pistons, clevite bearings.

Apexi powerfc djetro with hand controller, map sensor and intake temp sensor.

Tomei dump with trust front pipe

Arp head studs, Arp main studs, Arp crank bolt

Anyone want to buy some evo gear?

Built evo 8 head to suit evo 7 (kiggly beehive springs, 1mm os intake and exhaust valves, ported and I'm sure there is other stuff done I'm forgetting.

2.3 stroker with eagle forged crank (4340), eagle rods, arias 8.5:1 pistons, clevite bearings.

Apexi powerfc djetro with hand controller, map sensor and intake temp sensor.

Tomei dump with trust front pipe

Arp head studs, Arp main studs, Arp crank bolt

yes, but not that stuff...

i will accept it if you will give it to me for free... and ship it to vic for free... and install it.......

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Coming home late at night and driving past the police is the only reason i need one haha And yeh, definitley needs a switch to quickly enable it, dont have time to be getting my phone, opening an app, waiting for it to update etc before being able to make the change
    • Because it is financially convenient for them lol. Why wouldn't they want to give you the lowest possible valuation for your car?
    • Yep. @Duncan also shannons they will rip you dry and will be probably limited on how much you can drive. Also keep in mind that you always have to have it garaged with Shannons, with enthusiasts as per their PDS you can have it 2 times per week on the driveway for example. 
    • I had a generic 4" Varex rear box on my old V8, worked a treat for sneaking home late at night, it was as quite as stock when closed The car was "fairly" loud when open as it consisted of 1" 7/8 headers to 3" catted Y pipe, to 4" single, it did have a resonator in the mid pipe and only the Varex out the back I also hard wired in a Varex dash mount switch, as the key fob thing is a pain to use when driving I wouldn't recommend giving the beans when it is closed though as it creates a large restriction in the exhaust  It also can in very handy when pulled over for "random" breath tests or just cruising past the constabulary   
    • Here is the before and after of the scraping/sanding of the IC pads on the tachometer board for the fix mentioned in this thread. And yes it worked fine after. Just a note if you change any components on the board the tach calibration can be wrong showing the wrong idle etc...only problem is once it is installed back in the cluster you can't get to it to adjust...ouch! My fix was to cut out the calibration pot (the blue one) from the board and run it with two wires to the fuse panel under the dash where I could adjust the idle calibration once everything was installed. And yes I soldered everything up again including the half soldered components either side of the IC in my photos                                
×
×
  • Create New...