Jump to content
SAU Community

Recommended Posts

Semi's fitted, boot full of e85... Bring on Sandown tomorrow.

I just hope I can wake up that early, I struggled to get up at midday today. :P

picking up some spare fuel on the way there, car desperatly needs a wash so quick rinse in morning, fuel and then fun times..

46 entries what was the wrx day 120...if things go well you will be doing a run for more E85 part way through the day..

Semi's fitted, boot full of e85... Bring on Sandown tomorrow.

I just hope I can wake up that early, I struggled to get up at midday today. :P

Oil change done, have 60L of E85, figured there's a station nice and close for top-ups if the car decides to last the full day, gonna go out there now and pack up a bunch of basic tools and stuff...

Clutch been slipping for a while then really badly last week or so. Pulled it out today. Pfft, plenty of meat left :P

not launching it hard enough

anyone know much about Nissan gearboxes? gloria has 4 speed auto RE4R03B. needs a shift kit pretty badly. some options:

1) Wholesale Automatics (and apparently Knox Automatics) do shift kits for the RE4R03A out of a patrol. might not be that dissimilar?

2) attempt to fit a M35 stag 5 speed auto and ECU, then try to source a shift kit.

also need to start thinking about diffs... R200 RC35 apparently. would be happy with a viscous or 1.5 helical/mechanical.

Y u no clutch diff?

clutch and mechanical same thing?

im guessing like everything else car related, theres no way to know if a diff centre will fit until you try to fit it? dont want to buy one and then its a no-go. reading about the long-nose and short-nose R200's :wacko:

http://www.ebay.com.au/itm/R200-lsd-4-1-5stud-/131472837583?pt=LH_DefaultDomain_15&hash=item1e9c644bcf

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...