Jump to content
SAU Community

Vic Wasteland Thread


R31Nismoid

Recommended Posts

hamish you cant be serious? its not Australia problem these people get in shitty little boats and try to illegally enter another country, do you think if you hopped in a little rusty dingy heading to China they would give two shits about you? no it would be your stupidity. Same applies for these economic refugees. (possible terrorists)

Its factually correct that Liberal has reduced the amount of boat people and the policies have deterred people from trying as opposed to the record number of arrivals under Krudd, Gillard & co.

I never said we should throw open the doors and let every person in, that's just what you assumed.

All I said was that turning boats around in international waters then getting on a soap box saying you have "stopped the boats" because technically they didn't make it to AU, does not actually mean the boats have stopped.

Link to comment
Share on other sites

It's stopped them coming to Australia and that was the goal here

Rather pay patrol to intercept in international waters than have to detain and process illegal immigrants here only for the same result or to let them queue jump

Link to comment
Share on other sites

If Schrodinger then held a press conference to say the cat was was not dead, that would be more accurate

With Zaky Mallah and Tony Jones fielding him questions?

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • People still have Skylines? I thought they're non-existent now. 
    • Harness update time have had great fun and learnt so much already so far with this project. I started off making both the ignition and injector sub harnesses in the hope any mistakes i made here aren't as hard to undo and learn from as the main harness.  A cool comparison of the old harness using presumably TXL wire and the new which is using Tezel. Also opted to use DTM plugs to keep the whole setup as neat and tidy as possible and tucked the wiring under the coil bracket to try and keep it all from sticking out too much. Although the injector harness, I'm not overly happy with as I'm still using the rubber boots that are supplied with the type of plugs it just looks ugly and sticks out like a sore thumb with the white identifiers so a slight redesign may be done.   Then it was main harness time and most importantly trying to route it nice and away from the heat it will use the OEM heater hose routing which is no longer present to keep the harness up high and secure. it's amazing how much smaller this harness is able to be compared to the old one. plugged everything into the emtron and with the help of the tuner again attempted to start it up and instantly fired up and running smoothly on all 6 which was a big shock to myself. So still some routing and adjusting to be done for the final fit up and installing a knock sensor harness plug which is in the post all has gone surprisingly well.     The old harness for shits and giggles.
    • They do that at random every now and then, with almost no detectable cause. Mine has done it a couple of times (over 25 years!!). Never worked out why.
    • I don't post on here and have been lurking for some time now. Many of the topics have helped me out more times than i can count. I was racing yesterday (11/9) and blew a front right CV shaft. I have spares so I popped a new one in. A thread i read previously said to check the engine mounts if you blow a front CV. Upon inspection, the front right mount was completely separated from the upper plate. This discovery saved me time and money, because i would have blown another CV if i went back out. Just wanted to thank you guys and wish everyone luck with with their builds. (Now if we could only come up with a solution for my power steering belt flying off after hitting the rev limiter, lol)
    • Either way he still need those style of spacer to go into the manifold because the photo he currently has is not going to work 
×
×
  • Create New...