Jump to content
SAU Community

Recommended Posts

Hi people

I got some 18'' mags with pretty close to new tyres on them. less than 200km on the tyres.

235/40/R18 Zetum tyres all around

Selling because I was told these mags came off an R33 - failed to mention I would need a 5mm spacer and to flare the front guards to make them fit.

so now I just want to recover mostly the cost of the tyres so I can get some new tread on my stock rims.

I don't know much about wheels, so I cannot offer any offset insight - there are some numbers inside the mags I could get a photo of if anyone thinks they might be the offset figures.

I'm pretty sure they'll need a balancing - can see where some of the little weights have come off already.

I'd like to get $800 for the mags/tyres - open to reasonable offers.

IMG_2011.jpg

IMG_2008.jpg

IMG_2010.jpg

IMG_2009.jpg

IMG_2014.jpg

Enquiries via PM or call/sms Raven on 0404-482-847

Link to comment
https://www.sau.com.au/forums/topic/380605-cheap-18-mags-fresh-tyres/
Share on other sites

Found the thread I got these tyres from -

where they were listed as:

JDM Deep Dish 18 inch Mags (Rear: 18x9.5)

If my memory serves correctly the fronts aren't as wide as the rears - I wanna say 8.5, could have been 8 (tyre monkey told me amidst a bit of a ramble)

Bump

Any offers at all - I'd consider trading for stock rims with good rubber or something to that effect

I'd even consider trading for fmic setup for r33 + cash my way, or cat back exhaust + cash my way (assuming sub $500 value)

don't be shy, I'll consider any offer

the back wheels fit an R33 perfectly

the front wheels need a 5mm spacer (illegal) and maybe some guard work.

I drove it for about 2 hours in total with the front wheels on - there's this corner in front of my drive-way which causes something to scrub somewhere around the front passenger wheel - I'm not sure if it's the tyre scrubbing on the guard or if my front bar was hitting the road, my driver side guard has been flared a tiny bit from a small ding just below the headlight and the scrubbing never happened on that side, so it could be something as easy as that.

You're welcome to come have a look, I'd be happy to put them on the car and show you exactly what scrubbing I'm talking about.

the back wheels fit an R33 perfectly

the front wheels need a 5mm spacer (illegal) and maybe some guard work.

I drove it for about 2 hours in total with the front wheels on - there's this corner in front of my drive-way which causes something to scrub somewhere around the front passenger wheel - I'm not sure if it's the tyre scrubbing on the guard or if my front bar was hitting the road, my driver side guard has been flared a tiny bit from a small ding just below the headlight and the scrubbing never happened on that side, so it could be something as easy as that.

You're welcome to come have a look, I'd be happy to put them on the car and show you exactly what scrubbing I'm talking about.

i wish i could but im in townsville

Number from inside the front mags:

30

18x8

and I can't be stuff taking the back wheels off to check them

PRICE DROP $800 Now $700 ono

Edited by Raven33

I'm not sure how they would go on a 34 - you're welcome to come over and see if they fit.

Here is a link to a forum thread about wheel sizes & offsets for Skylines - if what I think are the offset details on the front mags is correct then there's a good chance they'll fit

As for painting them, there are some guides in the DIY section that cover painting mags - doesn't seem to be too hard a job, more a test of patience

Here is a link to a guide on these forums.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...