My Laughable Dyno Results

[blue_vl_t]

[Trozzle]

LOL

[simpletool]

Keen to see the new dyno results

[SimonR32]

There is an extra 44% flow between 2.5" to 3"

Edited November 9, 2011 by SimonR32

[R.3.2.G.T.R]

awaiting re-test results

Edited November 10, 2011 by BWRGTR

[STATUS]

Needs the actuators wound up... lots. Your actuators are too soft... or you have a restriction. Your @ -7 power @19-20psi but with about 6 psi more wound in on -5's..

Its dropping over 5psi....

[Trozzle]

Needs the actuators wound up... lots. Your actuators are too soft... or you have a restriction. Your @ -7 power @19-20psi but with about 6 psi more wound in on -5's..

Its dropping over 5psi....

LOL Trent did you even read the last few posts?

[STATUS]

LOL Trent did you even read the last few posts?

can i confess to reading just the first page.... kinda shot for time.

My appologies will read the whole lot now

Read: ok yes... waaaaay to much booost, should be making that power on 18psi. Didnt even think to look at graph any closer as 27psi and 300 rwkw is kinda out there... my bad. @ 27 psi i would expect ~80-100rwkw more.

[Trozzle]

can i confess to the first page.... kinda shot for time.

My appologies will read the whole lot now

Few posts back is a picture of 2 exhaust gaskets - he had a 2.5" gasket where there should have been a 3". Hopefully that was the cause of the problem