Jump to content
SAU Community

Recommended Posts

1993 R32 GTR

140,000 KMS – Engine rebuilt using standard parts at 96,000 KMS (have receipts)

Engine:

N1 turbos

HKS mushroom pod filters

HKS blow off valves

PWR 42mm full alloy radiator & silicon hoses

Spitfire coilpacks

Reconditioned ignitor (genuine Nissan)

Brand new coil pack loom (genuine Nissan)

Brand new NGK platinum sparkplugs

Walbro intank fuel pump

Kakimoto cat back exhaust 3.75” to 4.5” tip

Apexi PowerFC L-Jetro

GFB manual boost controller (12PSI)

Injectors cleaned and flow tested

Gates timing belt

New standard water pump (genuine Nissan)

Suspension:

Custom ‘Sydney Kid’ Setup

Revalved Bilstein shocks & additional circlip grooves

King springs (low)

ARC front castor arms

Reconditioned rear lower control arms (genuine Nissan)

Rear alloy cradle bushes

New rear inner HICAS rack ends (genuine Nissan)

New dust covers and bump stops

Firm ride and great handling.

Interior:

Recaro racing seats

New gear and handbrake boots

Isotta steering wheel

Ultra Turbo timer

White NIZMO 320km display

Bubble free dashboard

Transmission & Clutch:

Exceedy heavy duty clutch

Unknown short-shifter

Exterior:

Front Bar just resprayed

Great condition bottom lip installed

Additional top grill deflector

ENKEI RP01 (white) some rash on all 4

Federal 235/45/17 all around 90% front, 100% rear

Sound:

Sony Xplode Bluetooth & AUX headunit

Focal components front and back (both have crossovers)

Alpine 4 channel amp

Sound deadening used in doors

If you are looking for a cheap, molested gtr or a high horsepower Sunday prancer this is not the car for you, if you are after a quality, cared for classic then read further. I purchased the car two years ago with the intention of never selling, this which was my justification in purchasing superior parts when cheaper items were available. It has been my reliable daily drive for 2 years however in order to continue my career I have had to go back to University. I have always erred on the side of safety hence the overkill with the radiator, ignition system and only running 12PSI. The car still puts out 220kws at 12 PSI (dyno printout available) and the white on white scheme is subtle but classy. I’m after 20K, the car owes me a lot more but we drive these types of cars for pleasure, not investment. Car is located in Brisbane, will be sold with standard plates and RWC will be supplied.

Michael

0412131599

Mykal_Duhig(at)Yahoo.com.au

post-8342-0-30221400-1319263275_thumb.jpg

post-8342-0-70452800-1319263285_thumb.jpg

post-8342-0-83342000-1319263296_thumb.jpg

post-8342-0-79046500-1319263305_thumb.jpg

post-8342-0-80798200-1319263315_thumb.jpg

post-8342-0-75479200-1319263325_thumb.jpg

post-8342-0-12033900-1319263334_thumb.jpg

post-8342-0-32809300-1319263345_thumb.jpg

post-8342-0-83903600-1319263362_thumb.jpg

post-8342-0-65200900-1319263371_thumb.jpg

post-8342-0-80797300-1319263384_thumb.jpg

Edited by CGB_R32
Link to comment
https://www.sau.com.au/forums/topic/380910-1993-r32-gtr/
Share on other sites

Thanks for the kind words. I should add that the car will come with a brand new (not installed) mongoose M60B alarm (turbo timer and 2 point immobilizer)and has just has its QLD registration extended to April, 2012. Cheers.

Link to comment
https://www.sau.com.au/forums/topic/380910-1993-r32-gtr/#findComment-6077466
Share on other sites

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...

Be patient man. If this was a few months ago, I would have grabbed it. A white 32GTR is PERFECT, the best colour on a 32 IMO - knowing the fact that it had a rebuild not toooooo long ago is an added bonus. Be patient and it'll sell sooner or later, good luck man, she looks great

Link to comment
https://www.sau.com.au/forums/topic/380910-1993-r32-gtr/#findComment-6152318
Share on other sites

still for sale how much without running gear

thanx

I will keep it and live off bread and water before I do something drastic like this.

Or as Sinista said, it's yours for 20K :nyaanyaa:

Link to comment
https://www.sau.com.au/forums/topic/380910-1993-r32-gtr/#findComment-6171545
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • R32 pics Not sure if you can upload pics directly, but i've added them through an imgur link above.
    • There’s a possibility that Infinity G35x front hubs may be compatible, but it depends on the exact fitment. Sometimes, parts like hub and bearing assemblies from different models can work if the bolt patterns, bearing sizes, and axle specifications match, but the G35x hubs typically have a different design. It's worth checking detailed specs (like the number of bolt holes, size of the axle shaft, and bearing diameter) to compare, as Rock Auto does list some parts that cross over across different models. If you're going for a pre-pressed hub and bearing unit, that could be a good option. These units are usually easier to install, as the bearing and hub come pre-assembled, but you’ll still need to verify fitment, especially the outer diameter of the hub and bearing dimensions.
    • Love the input man! Defo gonna check it out
    • 1994 Series 3 R32 GTR. Freshly built as the perfect weekender. Has many brand new Nissan OEM pieces (some you can no longer source). Last serviced (April 2024) at V Spec Performance, Melbourne, Australia. Feel free to DM me if any questions. Asking price: $190,000 AUD.  Engine RB26DETT Original 05U block Factory R32 crankshaft CP 86.5mm forged pistons Spool forged rods Factory cylinder head – rebuilt Factory valve train Factory camshafts Factory inlet manifold Factory throttle body Garrett dash -5 turbos Custom intercooler piping with Plazmaman clamps Plazamaman 100mm race intercooler Turbosmart BOV Tomei fuel rail 660cc injectors Goodridge 9000 series fuel lines with crimped fittings Stainless steel front pipes Tomei titanium exhaust with stainless steel cat converter Spit fire coils Powder coated rocket covers New Nissan coil pack emblem badge Fully repainted engine bay in Factory Black Refurbished ABS unit New Nissan brake master cylinder New Nissan brake lines New Nissan clutch master cylinder New Nissan washer bottles Custom catch can (powder coated with Goodridge lines) Steering rack rebuilt New Nissan power steering lines New Nissan AC lines A/C compressor refurbished AC condenser refurbished HPI radiator and new thermos fanes New radiator fans NOTE: All nuts, bolts, fixings new or zinc coated Driveline Factory 5 speed gear box rebuilt Xtreme twin plate clutch Stainless steel clutch line Rebuilt factory transfer case Custom one-piece tail shaft Rebuilt factory front diff Rebuilt factory rear diff Suspension HICAS deleted Bilstein dampers IKEYA formular front and rear arms and tie rod ends New bushes wherever possible Whiteline anti roll bars (underneath car only) Brakes Brembo F50 front callipers – 4 piston AP racing 380*32 front rotors, J Hook design Custom floating hat and calliper mounts Brembo 4 piston rear callipers PFC pads Stainless steel braided brake lines Body New Factory Black paint job Ceramic coated exterior panels New Nissan aluminium bonnet (super rare) New Nissan headlights (super rare) New Nissan indicators New Nissan front bar New Nissan front lower lip New Nissan head light and bonnet seals New Nissan windscreen cowling New Nissan wiper arms and wiper blades New aftermarket windscreen New Nissan windscreen seal New Nissan front doors window surrounds and seals New Nissan rear quarter windows (must replace for proper paint job) New Nissan rear window surrounds and seals New Nissan side skirts New Nissan boot badges New Nismo rear bonnet lip New Nissan guard liners Interior New Nissan lens cover over cluster New Nissan gear boot shift New Nissan gear knob New Nismo steering wheel New Nismo floor mats New Billet Handbrake lever New Nissan OEM pocket facia to replace radio Underbody Original stone guard removed and new stone guard coating applied Powder coated front and rear cross members Fuel lines painted to match factory colours Fuel tank removed, cleaned, repainted and refitted All nuts and fixings cleaned, repaired and zinc plated Wheels Rays/Volk racing TE37 18 x 10.5 + 15 in Bronze Yokahama A050 265 x 35 x 18                         
×
×
  • Create New...