Jump to content
SAU Community

Recommended Posts

  • 9 months later...

I am going to do this soon myself but was going to use Gloss Red Caliper Paint. hmmmmm...options...

I even bought a spare cover incase I'm not happy with the end result. See how it goes. :thumbsup:

I did get around to doing this, used plastic primer and caliper paint. Gently peeled off the badge and reattached with fresh double sided tape.

I only just put it on so I guess time will tell how it holds up.

post-78856-0-28473300-1344255188_thumb.jpg

  • 4 weeks later...

you can use normal automotive basecoat and clear, the heat will not affect it.

think about how hot a panel gets in the middle of summer out in the sun? the paint doesnt peel off then, so it wont on the bay either.

rub the cover with 800 wet paper.

wash it with soapy water to remove all rubbing residue and sludge.

clean with prepsol/wax and grease remover.

apply plastic primer, but apply fine coats, not heavy coats, as this can cause imperfections in the paint.

apply paint within 15 minutes of applying plastic primer.

good luck!

  • 2 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sadly I can confirm if you are actually seeking to drift, you will quite easily spin up one wheel. Even if you're going in a straight line. I am not entirely sure of the metrics/terminology here but there's only a certain amount that the helical will actually spin both wheels. I've seen it on video with my own car where two lines of smoke switch over to just one after you really get in to it. Unlike with a clutch diff where you can keep your foot planted until the car regains grip, in my experience with the helical you want to be utilizing traction control allowing LIMITED slip or lifting (partially) when you start to spin up both tyres with a Nissan helical. Which makes them pretty sub optimal for drifting duty. That said... this is probably a helical on numbers alone. Just put the Kazz in
    • Let's just fix the problem by f**king the rest of the gearbox.
    • Unlikely, as per Greg's post. This is not helical diff behaviour unless one wheel is up off the ground. Shimming what? You don't "shim" a mechanical LSD. Probably not in the sense that you have heard of people "shimming" a diff. And the process that Nissan f**kwits call "shimming" a diff involves super-preloading a VLSD cartridge against the side of the diff to create a friction/wear point (in a place that it wasn't supposed to have one) to make the sloppy, useless, viscous diff into a hybrid viscous/mech abortion. In case it isn't clear, I consider the process to be stupid. Nike.
    • How much does the shifter move when the car is in gear with the engine off? If it is more than about 1cm you need to replace your shifter bush. Your shifts will just get crunchier, not faster, with a short shifter unless you also rebuild the whole box
    • I should video mine, will prob do it tomorrow    Between 1st and 3rd, you could fit another two gears. That is how loose and wobbly it is   horrible:(
×
×
  • Create New...