Jump to content
SAU Community

Recommended Posts

Yes that particular VQ motor may have come out in 1994 BUT it was not a VQ35DE. You are comparing apples to oranges.

The VQ35DE came out in 2001 and no earlier. Just because they're VQ motors does not make them similar in any way other than the 6 pots.

And I don't forsee 6pot motors getting higher in capacity. More likely 4 pot turbos or big litre 4's, economy will be a design factor no doubt

I would respectfully disagree, the VQ specifies much more than '6 cylinders', it is the series of engine, and I would argue that the VQ35 shares many similarities to the VQ40, VQ30, VQ25 and VQ20, in the same way the RB series of engines are all quite similar, there are a lot of relativly minor changes in the life of the VQ, turbo chargers, variable valve timing, direct injection, different bore/stroke/piston sizes (and therefore capacities), external changes to suit vehicle mounting positions, etc. Any major changes to the design of the engine would result in a different series name, for example, the VR engines used in the GT-R are based on the VQ, but due to the number of changes, they specified a new series.

The same thing occured in the early 1990s with the VG engine, Nissan produced the VE engine for the USA J30 Maxima, it was essentially a VG block with a chain driven twin cam head specifically built to fit in the Maxima, but because the difference were significant, they re-labled it a VE.

If the VQ35DE was an all new design/build, it would not carry the VQ series label.

This is the next generation Infiniti / Skyline codenamed the V37 (surprise surprise). Basically all the writing is about how Nissan and Mercedes will now be in co-operation to supply engines to eachother as already discussed in this thread. So basically, they will have the following motors available in their cars:

- 3.5L V6 turbo petrol

- 2.5L V6 hybrid

- 3.0L V6 turbo diesel

- 5.5L V8 petrol

So I think the VQ37VHR is history, to be replaced by the 3.5L V6 running a small turbo. Then they have the hybrid which will basically produce as much power as the 3.5L V6 turbo, and MB will provide the 3.0L V6 turbo diesel and 5.5L V8.

This is the information I have collated, not 100% guaranteed as it's still mostly in development but that's how I understand all of it. They will retain the VQ engine series in everything but the V8, which is the MB motor. I'm guessing the V8 will either be an Infiniti Performance Line (IPL) car, and some of the motors will go in the G series, and others in the M series.

If anyone else can confirm/deny this information, please do so. There's a lot of information collated from different sources, but that's my understanding!

new+Nissan+Skyline+%2528Infiniti+G%2529+%25E6%2597%25A5%25E7%2594%25A3%25E3%2582%25B9%25E3%2582%25AB%25E3%2582%25A4%25E3%2583%25A9%25E3%2582%25A4%25E3%2583%25B3+2013+1.jpg

new+Nissan+Skyline+%2528Infiniti+G%2529+%25E6%2597%25A5%25E7%2594%25A3%25E3%2582%25B9%25E3%2582%25AB%25E3%2582%25A4%25E3%2583%25A9%25E3%2582%25A4%25E3%2583%25B3+2013+2.jpg

Infiniti-102.jpg

infiniti-G-front-three-quarters.jpg

OK guys, done some further investigating, taken directly from the magazine I posted yesterday. The power figures should be as follows:

3.0L V6 diesel - 211HP (confirmed in article)

5.5L V8 petrol - 387HP (confirmed in article)

"V6 petrol" - 272HP (confirmed in article, no idea what motor size though)

Note the last one, I believe this is ANOTHER motor produced by Mercedes Benz, best answer I can come up with is it seems likely they are releasing DIFFERENT motors in the US/Europe as Infiniti, then different motors in Japan as Nissan. That is what the article is about - sharing motors between MB and Nissan, I wish I could translate the entire article, would provide a lot more details but I can only make out certain parts of it. And my Japanese is not good to begin with, anyone who could translate it would be able to confirm everything I have said.

But there is a rumor I read that the "main" V6 (which is the one sold by Nissan in Japan, who knows if it will make the US/Europe) should be producing around 335HP, and it may be called a VQ35VHR (as opposed to the V36 which was originally released as a VQ35HR, then VQ37VHR in later models). Again, whether they will have different power outputs per country (the V36 Infiniti sold in the US produces less power than the V36 Nissan sold in Japan, same motor but different air filter/system to get around some strict air pollution regulations in the US market), or whether the sedan/coupe will have different power figures OR different motors available, who knows. From what I understand, Carlos Ghosn (CEO of Nissan) has stated that they want to collaborate with MB to develop motors/technology, but whether that is only for the Infiniti (US/Europe) or includes Nissan (Japan), I'm unsure.

So to sum things up, the Infiniti US/Europe will most likely get their own motors (the 3 mentioned above), while Nissan Japan will have their own or a mix of the motors. Hope this helps clear things up a bit, I'm still not 100% set on the details, but that's how I understand it. For anyone really interested, there is an article I found called Nissan Skyline Episode 13: The Legacy Continues - helped confirm some details for me and may explain the situation a little better.

387hp from a 5.5 V8?

Merc detuned? glare.gif

Yep, they have confirmed it's an AMG 5.5L V8 de-tuned to run less power. Maybe they feel the chassis can handle only so much power, or a gentleman's agreement as MB wants to protect their C63 AMG from being overtaken by a dirty Nissan/Infiniti ;)

i cant see them changing too much internally, if anything at all. that will just make production take longer and more parts to manufacture. they may change intake and exhaust, and then tuning. its cheaper to produce one engine and tune it down with ECU changes

It's actually pretty funny with the V8, the old AMG 5.6L V8 from 1986 was putting out 360HP, but the new AMG 5.5L V8 (naturally aspirated, not the twin turbo monster) now puts out 420HP, and the NA motor is actually a DE-TUNED version of the twin-turbo variant. So they're going to de-tune a motor that is already de-tuned? Doesn't make sense to me. Although Nissan has a history of producing motors with de-tuned power per model, ie. the 2006 Maxima had a 175kW VQ35DE, same motor that went into the 350Z and Murano but they both had 195kW. But then in 2009 with the new Maxima the power went up to 195kW, so who knows what they are doing. And again, they did the same thing with Infiniti in the US to get around strict air regulations, slightly de-tuning the V36 there by restricting the air flow system.

Again, we have to remember these power figures I produced are for Infiniti in the US/Europe, and eventually here when it goes on sale in late 2012. It's not confirmed if these are the power figures and motors for Japan. As I said the other day, the "main" V6 the Japanese V37 Skyline should come with is going to have 335HP already with a single turbo 3.5L V6, so I see little point in them releasing a 360HP naturally aspirated V8 when the V6 will basically be on par with the V8 already when taking engine weight into consideration. Why would you bother buying the V8 when you could buy the V6 and just bolt on a bigger turbo and get more power anyway? Does not make sense.

Another thing I will point out, the existing Nissan Fuga (the next model up from the Skyline in Japan) is sold in the US/Europe as the Infiniti M37 (3.7L V6, same motor) then the next spec up is the M56 with a 5.6L V8 that puts down 420HP already, so why would they put in a motor with less power to supersede it? Makes no sense to me, I find it very unlikely they are going to go backwards. I would say they are going to pick and choose specific motors in different markets, like they did with the Maxima and Murano/350Z here years back. These motors mentioned above are the NEW motors to be brought in and sold, doesn't say anything about deleting the old motors, so they may have different variants of V6's and V8's available. There have been rumours for ages in Japan that since Nissan dropped their last V8 years ago and as they now only sell V6's as their premium models, they are looking to make something big this time. I would agree, they are going to come back with something more powerful. They always do.

a few reasons they will probably do that, in no particular order:

1. economy

2. torque may be higher

3. euro emission standards

4. car may be lighter, thus needing less power and torque to move it

5. less power means less of a load on the engine, thus they can make it cheaper

6. people probably wont put a bigger turbo on the V6 and prefer owning a V8

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Bit of an update to this one. Having some issues on the dyno that held us back (boost spiking) and I want to pass some info over you guys and see what you think is wrong with my setup. The current readout on this dyno is 462rwkw on a low reading dyno so keep in mind it is a real world 500rwkw setup on a hub dyno. Don't read into the power figure too much as a sign of the issue. The short and curly of it is: 2.8 Litre Racepace build RB25 NEO N/A Head with VCT (internally standard however ) Borgwarner EFR 8474  Turbosmart 50mm Straight Gate + Mac valve 6Boost Manifold 4" dump to full 4" exhaust (nil restrictions) Wastegate plumbed back in and all angles in the exhaust system are acceptable and not too sharp. GFB SV52 BOV in cooler piping  Turbosmart BOV in EFR Housing   The issue we are having is it comes onto full boost for example at 4000rpm and spikes to 24/25psi, before dropping down to 17psi before slowly rising back up to the target boost of 23psi. It was extremely uncontrollable and the tuner actually had to ramp in boost progrssively with each 1000rpm on each boost setting we selected to try and reduce the amount of spiking. Sometimes we would see a drop of 10psi from the peak at the beginning of the run, to the low, until it took the next 500-1000rpm to stabilise back up to the target boost. The tuner is pretty confident that the straight gate is just a poorly designed product and leaks too much boost upon cracking the gate open and theres no way to fix it other than going to a poppet valve. He's also confient theres no ignition breakdown or floating valves. The fueling is extremely stable as well. Turbo speed is somewhere around the 109,000rpm area. The spanner in the works for me is that prior to this Borgwarner and StraightGate, the car was tuned on -5 twins at a diferent tuner, and he also had issues controlling the boost with it spiking around the same rpm range, so to me this sounds like the same issue and it can't be anything on the turbo side as this was all changed and I think the behaviour is extremely similar, if not the same. We also removed the mac valve and did a run on wastegate pressure and it still spiked and had the same behaviour. My thoughts on possibilities are: Boost Leak VCT Cam Gear isn't reliably activating consistently - (On this however, we did a run with the VCT disabled and the boost still spiked) Turbosmart BOV is not handling the boost? However this seems unlikely to not be able to handle 20psi. I have a couple of logs that I can't make sense of if anybody knows how to read them and can obtain further logs of other parameters if they are not enough, happy to pay for anyones time. The dyno readout with the power figure is the most recent last week. The other picture is from two weeks prior to that where we couldn't break 400kw (we removed the cat), however the issue of the boost control persisted. @Lithium @Piggaz @burn4005 @GTSBoy @discopotato03 I've tagged those that were quite active in recent pages here, no disrespect to those that know turbos well but I missed tagging. Cheers 
    • I recently purchased a 2018 Infiniti Q60, which has an SD card navigation map. I can see my system has options for real time traffic updates etc, and am wondering if there is something I can purchase to get this working? I can see there are at least updated maps for USA and Canada, but nothing for Australia. Surely Infiniti took changing road systems and city expansions into account when they decided to use an inbuilt navigation over Android Auto/Apple Car Play, or are we doomed to drive on streets that don't exist in the navigation system if you drive to a new area?
    • Luckily I didn't put in etch primer as I just found out it's not compatible with my body filler lol. Also just need to sand the panel anywhere between 150-400 grit so I'm in the clear there. It does say to not apply to soft old paint, I assume that means paint that is flaking, peeling,etc
    • @dbm7 and @GTSBoy thank you both very much! will give that a shot!
×
×
  • Create New...