Jump to content
SAU Community

Recommended Posts

I think you are a retard lilcrash.

You continue to be a fool and blame the turbo, yet, many of your symptoms to me could be many other things.

You had no clue what you were doing when you were rebuilding the engine.... Surging...

Could be anything,

like the timing gear..You could have a tooth out somewhere..

Or you could have a faulty AFM

or you could have a f**ked sensor...

Or you could have a f**ked CAS

Or while you're pulling your dick you could be accidently pumping the throttle...

Stop blaming the turbo that works on everyone elses car, and find the REAL problem. Stop being a lazy, whiney, spoiled little c0ck.

  • Replies 886
  • Created
  • Last Reply

Top Posters In This Topic

I have an idea.

Stao - send him a new turbo (no deposit or anything)

lilknob - you install new turbo, then send your old one back.

If you don't send the old one back, Stao gives me your postal address, I beat you sensless and post pics in this thread and have the title changed to "Thread for my brain problems"

Everyone's happy.

Honestly, if I were Stao I'd refund you the cost of the turbo purchase to stop these retarded posts.

Actually, how much do you want for the turbo?

I'll give you a stock RB25 turbo plus cash for your hypergear turbo.

Then I'll send it to Stao for a free replacement to a current stock item.

Then he can pull apart the "faulty" turbo and investigate if he had enabled the "Make car run like a bag of shit" setting on the compressor wheel when it was initially assembled.

Edited by TTT

Honestly, if I were Stao I'd refund you the cost of the turbo purchase to stop these retarded posts.

Was going to agree but I think Stao has already done enough. Plus some of these post have gone well beyond defaming a business.

Kando seller is blocking customers if feedback isn't 100% yet Stao is still trying to help here

  • 1 month later...

Apart from the tune and usual underpoweredness it was sold in perfect running order. I couldn't deal with having a car with that I put so much money in being slower then my wife's accord. Now I've got a v8 Audi. Soon to be supercharged. :D

Edited by lilcrash

Hi all, first ever problem with my skyline in three years.

I have absolutely no power whatsoever when I try to start my car. Initially I thought it was a dead battery and had been jumping starting it until I have the chance to get a new battery, however the other night it happened again (believed it to be a dead battery) and when I went out in the morning it did not require a jump, started fine.

When it's dead there is no 'clickig' while trying to turn over, no warning lights etc whatsoever.

Could this be the starter motor/alternator?

Any ideas or help would be much appreciated.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
    • 440s will support well over 400HP on petrol, which is a decent place to be for an RB20. 230+rwkW. Will be a safer bet for idle/low load. 550s would be nice for the extra headroom. I've made the same decision with mine (Neo25). 1000s are probably too big for the Nistuned ECU, so I have some smaller ones.
    • Appreciate everything guys. I did go ahead and get an alignment... most of my complains are solved. Car is not perfect, but it's good enough. If I notice uneven tire wear or anything I'll just take everything back to stock.  Thanks again!
    • They still have not shipped the 550cc injectors as they weren't in stock, so in theory I could ask to get the 440cc ones instead, if those work better in my scenario. They're the same price so really shouldn't be an issue. Unfortunately I am not so knowledgeable in most parts of tuning so I wasn't sure what's best to choose between the two. 440cc ones are the lowest they have (not in stock, but available to buy nonetheless).
×
×
  • Create New...