Jump to content
SAU Community

Recommended Posts

  • Replies 62
  • Created
  • Last Reply

Top Posters In This Topic

i dont think there even is a cooler car than a worked '69 camaro

12082011654.jpg

:rofl:

I went past this place the other day and they actually had a late model camaro, not the new ones but the older pointy nose ones and they had grafted a 69 front and rear onto it ..couldnt find it on the net but i did find this..

IMG_9927.jpg

definatley different..

  • 5 months later...

Separate motors drive the front wheels. RW dedicated.

I didn't like the open top version.

No mention of damping or chassis; but based on a Lexus in some ways.

It'll be interesting to see if propellers can be put on it.

Strong yes. But not as strong as what the yanks make out

Much better oiling system than an RB. Internals aren't forged just very beefy. 12 counter weight crank etc

The heads aren't as good as RB25/26s though. So usually need a few psi more to make the same power

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey all, ordered this recently for my M35 but completely forgot there's a major difference between RWD and 4WD front crossmembers so it doesn't fit Not confirmed but I suspect it may fit RWD M35 and G35 Z33 350Z/V35 Under engine bash plate This is for the bash plate only, no bumper retainer Make an offer Pickup only, Brisbane inner-west Cheers, JB
    • Yeah do that, it’s only 120kAUD!!! You should have that sitting in the ashtray 
    • If you are genuinely considering trying to get this engineered, I would strongly advise finding the engineer that is happy to sign that off first before you put the hole in your car.  I've seen cars get defected for this and not be able to be put back on the road as no engineer they spoke to was happy to sign if off.  
    • Apologies, while id like to put the MAF as close to the TB and relocate the recirc, this may be too much work. Will most likely end up just putting it on the original AFM spot ( onto/next to the airbox ).  Was going through nistune, found a pretty nifty doc on this. Nistune MAF Notes. Also, i was looking through the bay, and there seems to be a tube/line connected from the A/C to the intercooler piping ( Between the smic and the recirc), what does this do as the crossover fmic piping doesnt have any connection? plumbing? not sure what you call it but the nipple thing ahah.  Also, been reading up more about crossover fmic in regards to the legality of having the hole drilled for the piping, this would most likely need to be engineered right?
×
×
  • Create New...