Jump to content
SAU Community

Recommended Posts

Hi every1,

Im having issues with weak radio reception in my r34.

Done some research and found this thread - http://www.skylinesaustralia.com/forums/topic/250936-weak-radio-signal/

Just wanted to clarify, on my stock harness I have a blue cable with 'Ant control" on it, that isnt connected to anything.

Is this the wire which I should be soldering in to an antenna wire on the back of my head unit (Im pretty sure there was one).

Just dont want to screw anything up and plan on giving it a go tomorrow.

Have taken a picture of the harness so u can see the wire im talking about.

Thanks heaps in advance.

post-86021-0-75429300-1320489562_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/382164-r34-gtt-poor-radio-reception/
Share on other sites

yes follow the instructions and you be right

but note

GTT and R34 in general have horrible radio reception,

tint affects it- some are ceramic, or metallized

landscape does, hills. mtns, builidngs

mutipath in citys does, reflection off metal objects causes mutiple paths of signal to hit the receiver causing drop outs

nissans horrble idea of diversity antennnas in the glass , not a good ground plane

most of the time the hack who installs the jap to oz signal box cuts the wires and tapes them up. not buying the right jack to interface it. thats the first place to check radio reception issues on JDM cars- NISSAN for sure

and if your still having issues check behind the c pillar sail panels in the rear , sometime the antenna wires into the rear glass are unplugged ? or cut

and now with DAB broadcasts you need a better antenna then factory . I use a amplified shark fin(smaller then you pinky finger long). tiny one for DAB tv and radio, works a treat and not horrble looking like some fins

hope that helps before you rip your hair out

  • 2 years later...

Hi guys,

Apologies for the thread revival.

I have installed a Blaupunkt New York 800 in my R34.

I've used an aeropro (from Repco) ISO to Nissan adaptor.

Anyway... the blue wire (ant control) as shown on the OPs pic - where do I actually connect this to on this particular HU?

On a slightly unrelated question - is there some sort of auto dim function (wire) for the HU when I turn on the headlights? As I find the HU way too bright during the night and am forced to manually dim the unit via software settings.

the link to the thread from OP mentions having an adaptor to the antenna and an extra single pin plug. I currently have this adaptor from JB hifi

http://jcbid.com/images2/9/3/6/7/2//full/SCOSCHE-NDAB-NISSAN-DIVERSITY-ANTENNA-ADAPTER.jpg

the original connection goes into the right side female end, and the red plug goes into the antenna hole in my head unit. What do i put into the remaining end?

My reception is dodgy and scatty :(

  • 2 months later...

Recently replaced the windscreen in R34 GTT 4 door and now my radio reception pretty poor.

I believe the aerial is in the windscreen but my new screen does not have one apparently.

what is the best solution?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...