Jump to content
SAU Community

Recommended Posts

Andrew, I'd def challenge a 61 or 62 in a 60 zone.................no speedo is that accurate so I wouldn't pay and just opt for conviction

Too late once you've paid cause they deem it as an acceptance of liability

^^^ Nope, no leg to stand on. As part of Victorias Certificate of Roadworthiness you can get your speedo checked/calibrated for free. And in this age of GPSs and smart phoines, to argue that you were speeding cos you didn't know any better is a cop out. Even more so when they have speed check signs all over Melbourne.

Don't get me wrong, I cruise around Adelaide all day every day doing 65km/hish and love how lax the enforcement is here. But in Vic I ALWAYS stayed below the speed limit.

I still doubt that they could argue calibration of 1km..........considering a tyre 50% worn at 100kph would indicate a different speed (as small as it may be) to a brand new one on the same calibrated vehicle

The tolerance for reading an analogue gauge is +/- half the smallest increment, so if you have 10km/h marks on your spedo the reading error is 5km/h, and you can get number of books or 'expert's to state that is the case.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've watched some vids and the technique seems to be to butt the sheets up to one another and use MIG to spot weld and slowly fill in the spots until its eventually all sealed. No runs as you would normally do, as there's too much heat generated that way. Yeah my stick welds are terrible these days because its been so long since i've done any of it. I expect to be spending many hours practicing
    • I have personally seen a Tomei USA RB26 cam that didn't even fit the head. Kind of nuts to me that it was even possible for that to happen but such is life.  There's two UP Garages in the US. One is a US branch of the Japanese company which sells things they brought over at tremendous markup. The other is University Place Garage/Fairlady Motors which is a shop best known for putting VCAM in RBs and trying to convince people to stop putting in 800hp of turbo on a 2.5L motor.
    • Gasless MIG is not exactly suited to what I would call "delicate" or "attractive" welding. So I would rule it out for sheet metal rust repair type stuff, unless you're only doing it in hidden places. I'm thinking about getting myself a gasless MIG for "hack together" type work. Noting that my welding experience is very very low, and quite a long time ago. So I'm also looking for "simple", but I'm not expecting "excellent". I'm not even sure that proper MIG is the best for sheet metal work. I get the feeling that the degree of control and the minimisation of heat input that you get from TIG is probably what you really want. And then you have to get good at doing it before the welds won't look like a monkey flinging a handful of shit anyway. You're probably SOL for an easy and cheap way to get from where you are to where you want to be. Much like myself.
    • Any recommendations for what would be the easiest welding type to start on, for sheet metal rust repairs and maybe some exhaust piping too? Seems like MIG is the most common. Would gasless MIG be ok to learn on and do some simple jobs? I have a stick welder which has a Lift TIG setting, but i'm more interested in getting whatever's easiest to do, and most suitable, rather than using what i have.
    • Is the UP Garage in the US of Ayyeee even the real UP Garage?
×
×
  • Create New...