Jump to content
SAU Community

Stock Exhaust To Lend?

pac34r

By pac34r,
in General Maintenance

 Share

Recommended Posts

pac34r Enthusiast

pac34r

Posted
Posted

Hi all,

Don't know if I'm in the right forum here but will give it a crack.

I was pulled over by a cop a couple of weeks ago. No defect just have to get the car inspected. Few questions:

1. The green form cops gave me listed: excessive noise and pod filter fitted. The form I got from Office of Environment Heritage (OEH) has listed only exhaust to be tested. Will they "check" pod?

2. I'm in the western sydney area, Campbelltown to be specific. Does anyone at all have a stock exhaust or cat to borrow? Would anyone know if changing from high flow to stock cat, would that reduce noise?

FYI:

*The car is tested at 4800 revs, 90 DB for a pass. Revved it to 5000 and got 96-97DB.

*Xforce high flow cat

*Kakimoto 06regu

*Pod in enclosed box

Link to comment
https://www.sau.com.au/forums/topic/384690-stock-exhaust-to-lend/
Share on other sites
AngryRB Grand Master

AngryRB

Posted
Posted (edited)

Hi all,

Don't know if I'm in the right forum here but will give it a crack.

I was pulled over by a cop a couple of weeks ago. No defect just have to get the car inspected. Few questions:

1. The green form cops gave me listed: excessive noise and pod filter fitted. The form I got from Office of Environment Heritage (OEH) has listed only exhaust to be tested. Will they "check" pod?

2. I'm in the western sydney area, Campbelltown to be specific. Does anyone at all have a stock exhaust or cat to borrow? Would anyone know if changing from high flow to stock cat, would that reduce noise?

FYI:

*The car is tested at 4800 revs, 90 DB for a pass. Revved it to 5000 and got 96-97DB.

*Xforce high flow cat

*Kakimoto 06regu

*Pod in enclosed box

you could source a second hand HKS hi power silent muffler or a fujitsubo muffler fairly cheaply, they meet the noise standards in japan and are quiet but still sound very nice when revved high, that might sound even better too depending how loud you like the exhaust.

the cat wont make that much difference, i think its mostly the muffler thats making the noise cause i have a full 3 1/2 inch system with decat, and fujitsubu muffler, and its very quiet on an idle and still sounds good when given a bootful.

hope that helps

Edited by SliverS2
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • soviet_merlin
      Beers and skylines Fatz style

      By soviet_merlin · Posted

      Holy mother of downforce!  
    • GTSBoy
      Wont start unless i have the pedal to the floor

      By GTSBoy · Posted

      Look to cold enrichment then?
    • GTSBoy
      R34 RB20DE NEO + T ONLY

      By GTSBoy · Posted

      See my post here If you put the Haltech in, you won't have to worry about any of that. And, in case you're worrying about my lack of credentials in doing your exact swap, I put a Neo in an R32. There has never been a stock boost solenoid near my car and the Neo's ECU has never cared. Nor should it, because it is electronically impossible for it to care.
    • GTSBoy
      Help Understand GTT Boost Setup

      By GTSBoy · Posted

      That's 100% wrong. Did you wire in the boost sensor? If you did not, then that is 101% your answer. Neo ECUs do suck a bit.
    • Sxnjeet
      R34 RB20DE NEO + T ONLY

      By Sxnjeet · Posted

      Hello, I'm trying to make this thread basically the thread with all the answers to common questions regarding specifically the RB20 DE NEO + T engine, that comes in the R34. Answers will and only should be provided by those who have done this conversion or actually have some relevant real life experience please. Please feel free to ask questions in the comments if you have any so other members can answer. I feel like this thread is really needed, especially with more Americans buying (unknowingly going to regret it too) rb20 neo r34s. My first question being - What do you guys use for tuning? I have purchased a haltech elite 2500 Plug and play kit for the rb25det NEO because the ecu plug is the same, but I am unsure if any of the pins would need to be repined to match. Second question that I see asked very often - After this conversion, did you install the boost solenoid/ actuator? I see many people doing a + T setup on their rb20 NEOs while running stock RB25DET NEO ECUs with no tune. I am wondering how they are going about doing that and consistently abusing the car because many of these people have had these untuned setups running for a very long time. That was my original plan, but my engine cuts out at 5 psi of boost using the stock ecu with no tune and no boost solenoid/actuator.
×
×
  • Create New...